7-Way to 7-Way Trailer Wiring Extender

Question

Question:

Just want to be sure. Want to plug into 2014 Denali 7 pin into trailer when parked to recharge trailer batters. Now have to back up close to plug in. Would this do the job?

asked by: Jim W

0

Expert Reply:

The Bargman extension 50-67-210 has trailer ends on both sides so it would not work. What you would need is an extension that has a trailer end on one side and a vehicle end on the other side such as # 20027. I have linked a video review of this part for you.

expert reply by: Michael H

0

Answer 1

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 2

The two harnesses you mentioned are made by two different companies who have just happen to price things differently. I wouldn't say there's a big quality difference between the #50-67-210 and #TLW6510 but the #TLW6510 is two feet longer and…

view full answer...

Answer 3

You can use Optronics 7-way plug #A7WCB along with 7-way cable #54006-059 to give you a male-to-male 7-way with matching plugs. We do offer a pre-made 7-way #50-67-210 but it is 8-feet long, not 9-feet.

view full answer...

Answer 4

The Bargman 7-Way Molded Trailer Wire Connector #50-67-210 that you referenced uses a standard RV style 7-way flat connector on both ends. The socket it would fit would look like the part #PK11893. This style of 7-way is the kind that is very…

view full answer...

Answer 5

If you want to upgrade from your Jensen stereo #JWM70A we have a great option for you. Furrion makes a really nice Rv stereo #DV1230BL. This has an HDMI port to connect your laptop, as well as USB and AUX ports. It is also Bluetooth compatible so you…

view full answer...

Answer 6

It looks like the Northern Lights 10-2 EX CD SE is 18'-6" long and 8 feet wide, so the Classic Accessories Deluxe PolyPro III Heavy-Duty Truck Bed Camper Cover - 19-11/16' Long #CA80037 is the best choice. This cover will fit even with…

view full answer...

Answer 7

The Bargman 7-Way Molded Trailer Wire Connector 50-67-210 that you referenced has a male connector on either end of the harness. For a similar connector that has a male and a female end we have the Torklift part #TLW6510 instead as an option as…

view full answer...

Answer 8

The model number on you Jensen HDMI RV Radio will be on a silver sticker found on the body of the radio as shown in the included picture. You will need to remove the radio to read this sticker. Based on the pictures of your radio it appears that you…

view full answer...

Answer 9

I really wish I had a diagram specific to your 2004 Nissan Quest that shows how it would install, but the best I can do is show you a diagram that shows you what circuits the Curt Harness part #C56175 would wire to. You will need to use the included…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 12

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

7-Way to 7-Way Trailer Wiring Extender

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching