Availability of 1-Foot Brake Line with 3/8-Inch UNF Fittings

Question

Question:

Hi there I am looking for a 12 inch or 13 inch brake hose with brass fittings one female for a 3/8 OD male and one male 3/8 OD do you have that thanks

asked by: Jon S

0

Expert Reply:

We offer the Titan Hydraulic Brake Line # T0777300, which is 13-inches long. We also offer # T0776500 which is about 18-inches long overall. These flexible hoses have one male and one female 3/8-inch UNF connector fitting.

expert reply by: Adam R

0

Answer 1

Kodiak brake hose #BH-3MFS90FF-1-5 does not have that little clip you are referring to and Dexter hose #18018-SF does have it. For either line I recommend bracket #T0776300. For clips I recommend #T0776400.

view full answer...

Answer 2

The standard grease zerk fitting is 1/4" and that is what comes with most if not all the bearing buddys #BB2047SS. I've only had to mess with one standard size and use the Performance Tools Grease Gun #PTW54290. I suggest getting one because…

view full answer...

Answer 3

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 7

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 8

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 9

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Availability of 1-Foot Brake Line with 3/8-Inch UNF Fittings

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching