Does B and W Headache Rack Block Third Brake Light On Back Of Cab When Installed On 2013 Ford F-250

Question

Question:

Did not see rack on truck, Question does rack hide brake light on cab or does the light fit directly in center of lovvour?

asked by: Pete B

0

Expert Reply:

I called my contact at B&W and asked about your 2013 Ford truck.

They told me that the third brake light on the back of your truck cab would not be blocked when the Headache Rack, part # BWPUCP7500WA is installed. I have attached a photo of the headache rack and have noted the area B&W said the brake light would be in when the rack is installed. It is right between the small louver and the top bar of the headache rack.

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

The B&W Custom Headache Rack w/ LED Brake, Turn, Tail Lights #BWPUCP7541BA weighs approximately 128lbs.

view full answer...

Answer 2

I have two options for you to install a headache rack with lights such as the B&W Custom Headache Rack part #BWPUCP7500BA on your 2008 Ford F-250. However, both of them will require splicing as they do not make an in-line connector specifically…

view full answer...

Answer 3

I spoke with my contact at B and W and the length of the runners on the Rack part #BWPUCP7500BA are 32 inches.

view full answer...

Answer 4

The outside uprights on the Aries Headache Rack #AA111001 referenced in your question bend inward at a 21 degree angle about 3 inches up from the base. The uprights then straighten back up as they reach the top making another 21 degree angle. I have…

view full answer...

Answer 5

The Optronics LED Trailer Tail light - Stop, Tail, Turn - Submersible - 10 Diodes - Red Lens #STL72RB will use the PVC Grommet for 6-1/2" Oval Trailer Tail Lights #A70GB for mounting. With this combination the opening you need to cut is a…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Does B and W Headache Rack Block Third Brake Light On Back Of Cab When Installed On 2013 Ford F-250

Product Page this Question was Asked From

Continue Researching