How Much Does The B&W Custom Headache Rack Weigh

Question

Question:

How much does it weigh

asked by: Danny W

0

Expert Reply:

The B&W Custom Headache Rack w/ LED Brake, Turn, Tail Lights # BWPUCP7541BA weighs approximately 128lbs.

expert reply by: Kevin C

0

Answer 1

The outside uprights on the Aries Headache Rack #AA111001 referenced in your question bend inward at a 21 degree angle about 3 inches up from the base. The uprights then straighten back up as they reach the top making another 21 degree angle. I…

view full answer...

Answer 2

I have two options for you to install a headache rack with lights such as the B&W Custom Headache Rack part #BWPUCP7500BA on your 2008 Ford F-250. However, both of them will require splicing as they do not make an in-line connector…

view full answer...

Answer 3

The Optronics LED Trailer Tail light - Stop, Tail, Turn - Submersible - 10 Diodes - Red Lens #STL72RB will use the PVC Grommet for 6-1/2" Oval Trailer Tail Lights #A70GB for mounting. With this combination the opening you need to cut is a…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights at…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

How Much Does The B&W Custom Headache Rack Weigh

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching