Replacement Gear Set for Venture 5th Wheel Landing Gear

Question

Question:

Are these the gears for a venture model 9000 landing gear

asked by: Tom S

0

Expert Reply:

According to Lippert Components, their # LC146059 gear set replaces the gears in the lead leg, while # LC146060 will replace the gears in the follower leg. The gear sets are compatible with Venture landing gear.

expert reply by: Mike L

0

Answer 1

Lippert offers a replacement gear box which includes the collar, part #LC276602. This gearbox is identical to the Atwood #75054SP, except the Lippert version is manufactured of aluminum. At one time, Atwood had a metal gear box available but they no…

view full answer...

Answer 2

Yes, based on the picture you sent in the replacement gearbox part #LC276602 that you referenced is the correct replacement. This is aluminum too which means it will be a bit stronger as well.

view full answer...

Answer 3

Yes, I attached a diagram you can use to install the #LC146059 that you referenced.

view full answer...

Answer 4

The Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear #LC276602 is the one you will need for your 2005 Keystone Sprinter 252RLS 5th wheel. It is a direct replacement for your damaged Venture gear box.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Chip, so we do have a set of Torklift camper tie downs that fit your 2024 Ford F-350 long bed with side steps and a factory hitch with the part number #TL87CR for the front set and part #TLF3008 for the rear set.

view full answer...

Answer 7

Thanks for all the information! You are correct that is the lead leg because it is closest to the gear and the motor. However, in order to determine which replacement lead leg you need, you'll need to find the model of the landing gear on your…

view full answer...

Answer 8

Repair kit #LG-146059 contains 2 pins and the drive shaft all of which are for the top of the jack. To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions. The…

view full answer...

Answer 9

The Lippert Landing Gear Leg model LCI PN241846 on your landing gear system refers to the Lippert Heavy Duty Landing Gear Master Leg #LC241846. For a repair kit that will work nicely with this leg, you can use the Lippert Lead Leg Repair Kit…

view full answer...

Answer 10

The division at Atwood that handled the jacks and landing gear was sold off to Lippert so direct replacement parts are not available. But it is likely that the gear box and motor of another brand will still fit. And yes, the gear box and motor do…

view full answer...

Answer 11

For your Venture landing gear you can use #LC276602 or #LG-179015. Either one will work.

view full answer...

Answer 12

Since your Venture leg is the follow leg the repair kit is #LC146060. If you had the lead leg it would be #LC146059.

view full answer...

Replacement Gear Set for Venture 5th Wheel Landing Gear

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching