Will Camco RV Water Heater Anode Rod Work With Atwood Water Heater

Question

Question:

Hello,I have a 2006 Dutchmen travel trailer 25ft. It has a 6-gal. Atwood Hot Water Heater.It currently has a drain plug with no anode rod.The thread dia.is 3/4 in.Will this particular part work on this and would this length be proper for 6-gal h.w. heater?Thanks,I need one.

asked by: Doug S

0

Expert Reply:

I went to the warehouse and pulled one of the Camco RV Water Heater Anode Rod, part # CAM11553.

I took some measurements and have attached a photo of the rod with the measurements noted. The threaded portion of the rod measures just a little over 3/4 inches at .827 inches. You mentioned the plug you pulled from the water heater is 3/4 inch. I called my contact at CAMCO and they told me that this is designed to work with Atwood water heaters so this should work great for you.

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

If you take a look at the photo I added with some measurements of the Lippert Manual Pull-Out Step for RVs #LC432682 you can see the mounting holes are spaced 7" apart front-to-back and 24-1/4" apart side-to-side. You can use these…

view full answer...

Answer 2

The correct anode rod for an Atwood 6 Gallon Water Heater is the Camco RV Water Heater Anode Rod part #CAM11553 which measures 4-1/2" long x 1/2" diameter. There is also a version of this with a built-in drain valve, the part #CAM11533.…

view full answer...

Answer 3

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 6

The direct replacement for your Atwood Gc6aa/10E water heater has been discontinued. I recommend the Atwood RV Water Heater Item #DMC74FR which only requires a 12-3/4" x 12-3/4" cutout. This is a standard gas and electric, 10,000 BTU water…

view full answer...

Answer 7

Yes it is; for a 6-gallon tanked RV water heater, there isn't a better option than the Dometic: - Dometic RV Water Heater - Gas and Electric #DMC74FR At 10,000 Btus, this water heater has a higher heating capacity than other units for better…

view full answer...

Answer 8

The instructions for mounting the Hopkins Electronic LED Smart Level #HM08201 are the same for motorhomes and trailers. You can attach the level to your motorhome with the included bracket and adhesive backing. It also has three pre-drilled holes in…

view full answer...

Answer 9

If you look at the brackets of the TorkLift HiddenPower Under-Vehicle Battery Mount #TLA7727 you'll see that the top hook goes much wider than the bottom one. There wouldn't be a frame dimension that this will work with since trailer frames…

view full answer...

Answer 10

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 11

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 12

There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…

view full answer...

Will Camco RV Water Heater Anode Rod Work With Atwood Water Heater

Product Page this Question was Asked From

Continue Researching