Hopkins Electronic LED Smart Level Mounting Instructions For A Motorhome

Question

Question:

Are there instructions for mounting on motorhome rather than a trailer?

asked by: Charlotte A

1

Helpful Expert Reply:

The instructions for mounting the Hopkins Electronic LED Smart Level # HM08201 are the same for motorhomes and trailers.

You can attach the level to your motorhome with the included bracket and adhesive backing. It also has three pre-drilled holes in it, as well as included hardware for a permanent mount installation.The leveler can be removed from the bracket if needed.

If it were me I would place the Smart Level # HM08201 near stabilizer jack controls, if they are powered, or near a stabilizer jack itself if it is manually operated. That way you can make your leveling adjustments with the Smart Level right there.

expert reply by: Timothy G

1

Answer 1

What you are experiencing just means that you need to calibrate the Hopkins Electronic LED Smart Level #HM08201. To do this you need to set the Smart Level on a table and level it. Once the green bubble is where it needs to be you press and hold the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Hopkins Electronic LED Smart Level Mounting Instructions For A Motorhome

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching