Recommended Trailer Cargo Ramps For Can Am Spyder Motorcycle

Question

Question:

need a loading ramp with the dimension, 60 width. the length can be 3 or 4 ft I have a Can-Am Spyder to load onto my trailer, need ramp to support 3 wheel trike

asked by: Neece H

0

Expert Reply:

I did some research on the Can Am and found that it measures 61.9 inches wide. We do not have any one piece loading ramps that are that wide but I may have a solution.

I recommend using three of the Erickson Arched Loading Ramp, part # EM07464. This ramp is a bit longer than the 3 or 4 feet you mentioned. The ramp is 80 inches long and 11 inches wide. It can be folded for easy storage when not in use. Each ramp weighs 30-lbs and has a weight capacity of 800-lbs.

expert reply by: Jeffrey L

0

Answer 1

Due to the design of the CargoSmart Loading Ramp - Aluminum - 77" x 50" - 1,500 lbs #3483075 you will not be able to use it sideways, as the brackets individual ramps at the bottom and middle would not be supported by anything other…

view full answer...

Answer 2

Welding the hitch to your bumper is one solution. However there's a saying about thieves that goes, "a determined thief with enough time and opportunity always gets what he wants." It's a sad reality, but in your…

view full answer...

Answer 3

I am not sure what products you are referring to but the most safe, secure, and easy tie down method we offer for your Can-Am Spyder is a combination of the Erickson Horizontal E-Track part #EM19147 (3), the Erickson E-Chock Wheel Chocks part…

view full answer...

Answer 4

To secure your trikes, I'd use three of the #PK-WTD chock/strap kits to secure the wheels. This is a really slick system that would work great for you. The combination of the strap and chock will keep your rides very secure on the trailer. Each…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Recommended Trailer Cargo Ramps For Can Am Spyder Motorcycle

Product Page this Question was Asked From

Continue Researching