Will Erickson Heavy-Duty Retractable Anchors Fit 2013 Chevrolet Silverado

Question

Question:

Will these fit a 2013 Silverado?

asked by: Don L

0

Expert Reply:

The Erickson Heavy-Duty Retractable Anchors, part # EM01003, are listed as a fit for the 2013 Chevy Silverado. Check out the attached photos of the dimensions of the anchors that shows they will fit the stake pockets of your Silverado.

I have also attached a link to a product review video for these anchors you can take a look at.

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 2

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 3

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 4

For your 4x6 utility trailer, I recommend using the Taskmaster 4.80R12 Radial Trailer Tire part #TT48012C. This tire has a radial ply construction which will be better for the longer highway trips you intended to make. It has a load range C rating…

view full answer...

Answer 5

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 6

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 7

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 8

You're correct. The repalcement for your existing B12EA-22 brake would be #AKEBRK-7R-SA for the right side and #AKEBRK-7L-SA for the left.

view full answer...

Answer 9

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 10

Those look to be the slide flange-to-flange measurements, and we do have the correct slide toppers in black for each of them: - 74 Inch Measurement: Solera RV Slide-Out Awning #LCV000168105 - 159 Inch Measurement: Solera RV Slide-Out Awning…

view full answer...

Answer 11

Sounds like you are looking for a 7-way for a brake controller and a 12v hot lead for your 2008 Toyota Tacoma, so I would recommend the Universal Installation Kit for Trailer Brake Controller, part #ETBC7. This includes everything needed to install…

view full answer...

Answer 12

Installing the Union Tee #AL21838 with your #AL57575 will tie the pressure of the two air bags together. So yes, a shift in a very heavy load like a truck camper will potentially result in air being forced from one into the other. The reason I say…

view full answer...

Will Erickson Heavy-Duty Retractable Anchors Fit 2013 Chevrolet Silverado

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching