Height of Garnish Included With MaxxAir # MA00-04000K Trailer Roof Vent

Question

Question:

How tall is the included garnish?

asked by: Brent

1

Helpful Expert Reply:

The garnish that's included with the MaxxAir # MA00-04000K is 3 inches tall. I've confirmed this with our MaxxAir representative.

expert reply by: Mike L

1

Answer 1

Yes, you can use a 30 amp to 50 amp dogbone adapter like the Mighty Cord Dogbone RV Power Cord Adapter part #A10-5030FBK on a trailer with 30 amp surge protector.

view full answer...

Answer 2

If the vent fan you have now is reversible then there should be a button on the assembly next to the other controls. However, if the fan is not reversible then all you need to do is reverse the wires on the motor (not the circuit board) and that…

view full answer...

Answer 3

Good morning, Don. The 3/4" wide butyl tape is exactly what we recommend for installing a roof vent such as the MaxxFan #MA00-07000K. We actually sell a roof vent install kit part #344270KITW that comes with sealant, screws and a 30'…

view full answer...

Answer 4

I suggest pulling the 12 volt DC fuse and let it sit for 15-20 minutes to try and hard reset the 4900N MaxxFan Deluxe Roof Vent. You should check all the wires and connections for damage like corrosion, shorts or overheating. If this doesn't…

view full answer...

Answer 5

Your Greystone WF2613R fireplace has actually been discontinued, and its replacement parts are no longer available, unfortunately. I know it's not what you're wanting to do, however since your fireplace and its parts are no longer available,…

view full answer...

Answer 6

The correct replacement for your 1-065-041012-01 motor is part #LC141893 from Lippert. Your original motor had a 7140 rpm speed. The Stromberg-Carlson #LG-196308 you specified has a 5430 rpm output, so it wouldn't be a good choice. You'll…

view full answer...

Answer 7

The needed replacement part in smoke/tinted is, #FVK1020-19; this fits all 4000 series units like what you have on your motorhome.

view full answer...

Answer 8

It's pretty simple. A 4-bolt rail uses four 5/8 inch bolts ran through the floor of the truck bed into the frame brackets. The bolts run down through the center of the raised part of the rail, as shown in the photo I provided. A 10-bolt rail uses…

view full answer...

Answer 9

The MaxxAir #MA00-04000K is intended for roofs 2-6 inches thick, so it wouldn't work well right out of the box for you. However, this is an extremely common issue that'e easily overcome by using some lumber to built a frame around the inside…

view full answer...

Answer 10

From the edge of mounting flange that would sit on the roof to the inner plate that you would see inside the trailer is approximately 1-1/2". With it sitting down a 1/4" lower than the ceiling the mounting flange for the trim piece would…

view full answer...

Answer 11

Yes, we have the part #MA00-05301K which is the version of the part #MA00-06401K that has a white lid.

view full answer...

Answer 12

I went ahead and checked out the MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-05301K, and it turns out that you can use this in a bathroom application, however you are going to want to make sure that you aren't putting this above any tubs, showers…

view full answer...

Height of Garnish Included With MaxxAir # MA00-04000K Trailer Roof Vent

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching