How to Pick Out Trailer Bearings

Question

Question:

Hi I am looking for a complete new set of wheel bearings for my trailer, a Conway AT506 model 6x4 Do you have these in stock?

asked by: RICHARD G

0

Expert Reply:

I really wish there was a way to determine what bearings a trailer needed without actually pulling the wheel off and checking, but there isn't. The only two solution I have for you would be to remove the hubs and get the numbers that are stamped on the bearing or for you to remove the hubs and use a digital or dial caliper to measure where the bearings and seal ride (see pic).

With that info I can help you figure out what you need.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Yes, the Dexter axle part #7359765 that you referenced uses the same 84 spindle that you have measures. This will allow you to reuse your current hubs and bearings.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 4

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 5

From the information that I was able to find on the L44549 bearing, it shows it being a 1-1/16 inch bearing which is the same as Trailer Hub Bearing, #L44649. Just to be sure, I recommend measuring the L44549 bearing with a digital caliper to confirm…

view full answer...

Answer 6

The bearing part #L44649 has an inner diameter of 1.063 and is typically used in 3,500 lb axle hubs and the #L44643 has an inner diameter of 1 inch and is typically used on 2,000 lb axle hubs. If you can get me more info on your trailer like axle…

view full answer...

Answer 7

From what I was able to find out from my research, the Tie Down Engineering 11033 hub has a 5 on 4-1/2" bolt pattern and is designed for 3500-lb axles. Replacement hubs that have these specs typically use a #L68149 inner bearing and #L44649…

view full answer...

Answer 8

The Tie Down Engineering 11033 hub has a 5 on 4-1/2" bolt pattern and is designed for 3500-lb axles like the #AKIHUB-545-35-K. Then for a spindle the part #TRU84FR that you referenced would be what you need.

view full answer...

Answer 9

Thank you for all of the photos and information! From what I can see it looks like you have a #84 spindle but that inner bearing blew out so you should be able to remove that inner sleeve that looks like it's still on the spindle (next to where…

view full answer...

Answer 10

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

How to Pick Out Trailer Bearings

Product Page this Question was Asked From

Continue Researching