Towing Mirror Recommendation for a 2015 Ram 1500

Question

Question:

need to know if this product will fit the 2015 dodge ram Quad cab mirrors Code: KS80710 2014 Dodge Ram Pickup K-Source Custom Towing Mirrors - Snap On - Driver and Passenger Side

asked by: Edward C

0

Expert Reply:

The Longview Custom Towing Mirrors part # LVT-3100C that you referenced have been confirmed to fit the 2015 Ram 1500 so they would work well for you.

Check out the install video I attached as well.

expert reply by: Jameson C

0

Answer 1

I spoke with my contact at Longview and she said Custom Towing Mirror Set #LVT-3100C will fit the stock OEM side view mirrors on the 2014 Ram 1500 with the power folding feature. Your mirrors would be able to fold just fine with these installed.…

view full answer...

Answer 2

Yes, the Longview Custom Towing Mirrors #LVT-3100C that you referenced do stick out far enough to allow to see behind you much better when towing an 8-1/2 foot wide trailer.

view full answer...

Answer 3

Good news, I can help you pick out the right vehicle suspension for your setup. The Timbren Suspension systems are an easy no drill solution to correct the issue you are having. I would recommend the #TDRTT1500, because they will help bear the…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 7

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 8

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...