Does the # C13046 Hitch Install Require Modification of the Rear Bumper on a 2006 Subaru B9 Tribeca

Question

Question:

Do I have to modify the rear bumper to accommodate this hitch?

asked by: Knoel K

0

Expert Reply:

Installation of the CurtTrailer Hitch, item # C13046, does not require modification of the rear bumper or fascia. You will need to temporarily remove your spare tire, then you can replace it after the installation is complete.

Some items you may need to complete your Class III hitch setup are listed below.

Wiring # 118461
Drawbar # C45010
Hitch Ball # 19260 or # 19247
Hitch Lock Kit # e99039

expert reply by: Robert G

0

Answer 1

You can use the Curt #D210 with an adapter, but it will reduce the tongue capacity of your trailer hitch receiver by 50%. If that is acceptable with your combination then I recommend the Malone 2" Dual Purpose Hitch Receiver #MPG544 which will…

view full answer...

Answer 2

We do sell replacement hardware for all of the hitches including the #C13046 we carry with the part #RHK.

view full answer...

Answer 3

To install Curt trailer hitch #C13046 on your 2007 Subaru Tribeca you will only need to temporarily remove the spare tire from under the vehicle. After the hitch is installed, you will put the spare tire back where it was. There is no mention of…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

We have just what you need. If you type RHK in the search box on our website it will take you to the replacement hardware kit product page. You will then simply type the number of the hitch you need hardware for in the box that is labeled Hitch Item…

view full answer...

Answer 6

Absolutely correct; no drilling into the frame of your 2023 Lexus RX 350 is required, and you will use the existing frame holes to install the Draw-Tite hitch that fits, which is the following part number: - Draw-Tite Trailer Hitch Receiver #DT73QR…

view full answer...

Answer 7

The largest ball they make for Class II hitch is 2 inch. There are not any bigger sizes because the Class II hitch would not be able to handle the weight even if the ball is rated to handle more weight. There are bigger ball sizes larger than 2 inch…

view full answer...

Answer 8

All you will need is a mushing #58184 that will allow you to use the 1 inch ball shank in the 1-1/4 inch diameter hole on your weight distribution head. If you instead decide to get a new ball you can use #19286.

view full answer...

Answer 9

The Tow Ready 2 inch Hitch Ball #19258 includes a 1-1/8 inch nut. I just went out to our warehouse to check. It sounds like it'll work great for you.

view full answer...

Does the # C13046 Hitch Install Require Modification of the Rear Bumper on a 2006 Subaru B9 Tribeca

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching