Are U-Bolts Used to Install 5th Wheel Frame Brackets on a 2008 Ford F-250

Question

Question:

The printed instructions for this kit show only ONE bolt attaching each bracket to the framerail. They do NOT show use of the u-bolts at all. The pertinent video shows the same thing. Is this correct? It seems not much of a connection to haul 15k.

asked by: John L

1

Helpful Expert Reply:

I checked both the instructions and the video installation for bracket kit # RP50082. In both the u-bolts are shown in use. I have included pictures pointing this out for you.

expert reply by: Michael H

1

click to enlarge

Answer 1

Thank you for reaching back out and clarifying that, the reason you received a response talking about a 5th wheel hitch is because base rails are a 5th wheel product. What you are needing is something different than base rails. The TracRac's are…

view full answer...

Answer 2

I spoke with my Curt representative, who tells me that either Grade 8 or Grade 5 half-inch bolts are acceptable. In the past, they provided Grade 5 with their install kits, but recently changed to Grade 8. It doesn't matter which of the two bolts…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 6

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the industry…

view full answer...

Answer 7

The head alone for the B&W Companion hitch #BWRVK3500 weighs about 70 pounds. Everything else weighs about 130 pounds. So the total weight of the hitch is approximately 200 pounds.

view full answer...

Answer 8

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 9

To get the B&W Patriot #BWRVK3200 to work with your 2006 Dodge Ram you're going to need a set of 5th wheel rails #DM8552016-71. These rails are custom fit to your vehicle so they'll just bolt right up to the frame. It is worth mentioning…

view full answer...

Answer 10

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

view full answer...

Answer 11

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

view full answer...