Fit of UWS Replacement Locking Paddle Handle # UWSLOCKING on Kobalt Trunk Toolbox

Question

Question:

I have a Kobalt double lid tool box. Will your replacement locking paddle handle for uws toolboxes code: uwslocking work with this box. the handles look exactly the same to me.

asked by: Arnold W

1

Helpful Expert Reply:

UWS couldn't tell me if their # UWSLOCKING replacement locking paddle handle would work on your Kobalt toolbox, because they haven't tested it.

If the bolt hole patterns of your existing handles match those of the # UWSLOCKING shown in the provided diagram, the replacement handle would be a likely fit.

expert reply by: Mike L

1

click to enlarge

Answer 1

Check out the dimension picture I attached for the Latch Part #L4080 that you referenced. I believe the dimension you are looking for is 1/2 inch on all sides from the edge of the latch flange to the center of the mounting holes.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

Hello John. The Hot Dot LEDs #328-003-17A you were looking at are definitely a good option. Especially is you need something with the 2" center on center for the holes. We do have two other options for you to look at, take a look at the…

view full answer...

Answer 5

We have that size (see link), but none of the tires are radial. They are all bias ply as that is the common construction for the LT tires. The closest tire size that is radial would be the 235/80R16 like part #TTWTRTM2358016E. This size has a section…

view full answer...

Answer 6

Based on what we could find, the AL-KO 8490 is a 3,500 lb axle, and your info stating the 5 on 4-1/2" bolt pattern and 10" x 2-1/4" drum size supports that as well. I do recommend verifying what you need by taking apart your current…

view full answer...

Answer 7

Thank you for the photo. We may have a few replacement seal options for your Seal on 2001 SnoPro Clamshell Enclosed Trailer but you'll need to confirm the dimensions we have will work for what you're needing. The Rubber Large Half Round Seal…

view full answer...

Answer 8

In regards to a UWS Truck Bed Toolbox, if the box is locked and there is no key then you have two options. If you know the key number (it may be stamped onto the lock/latch) then you can order a replacement key like the Replacement Key for UWS…

view full answer...

Answer 9

The folks at Bolt tell me if their #BL7023547 lock would be compatible with UWS and DeeZee toolboxes, but they were unable to specify fit for a Kobalt toolbox, but if the latches you currently have match the dimensions of the diagram I've…

view full answer...

Answer 10

I contacted UWS, and they gave me a couple of solutions to get your tool box to open. UWS suggested to first try to push down on the top of the lid to make sure the lid is close all the way and latch. Then turn the key to the unlock position and then…

view full answer...

Fit of UWS Replacement Locking Paddle Handle # UWSLOCKING on Kobalt Trunk Toolbox

Product Page this Question was Asked From

Continue Researching