Looking for Submersible License Plate Light

Question

Question:

Looking to put a light on boat trailer license plate. Is this light submersible? Will be under water every time I unload and load boat. Anything else you would recommend if its not?

asked by: Justin

0

Expert Reply:

I have included a link to the submersible license plate lights that we offer. If you are looking for an LED light, take a look at part # LPL91CB. I have included a short video for you.

expert reply by: Leah S

0

Answer 1

I was able to pull up some information on the Triton 08478 light that you mentioned and it appears that the LED Trailer Tail Light w/ Flange - Stop, Turn, Tail - Submersible - 6 Diodes - Oval - Red Lens #STL73RB is the same part. I've linked a…

view full answer...

Answer 2

For a grommet to use with the clearance light part #LPL91CB you would want the part #A91GB which was designed for it.

view full answer...

Answer 3

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 12

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Looking for Submersible License Plate Light

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching