Testing a Brake Controller that the Power Level Is Either All or Nothing
Question:
When I try and adjust the blue power wheel it jumps from 0.0 to 14 without any settings in between?
asked by: Matt
Expert Reply:
Either the brake controller has an internal problem, or the wiring of the controller is at fault. It is pretty easy to test the setup to determine what is going on.
Sever the blue brake output wire near the brake controller leaving enough room to reconnect it and then apply the manual slide. Using a circuit tester like part # PTW2993, you should get output to the controller side of the wire you severed. If the manual slide activates the trailer brake output wire properly, try the brake pedal. If the brake pedal activates the brake output properly also then the problem is farther back either in the vehicle wiring or on the trailer.
If either the brake pedal or the manual slide are not functioning properly you will need to test the wires going into the brake controller. Make sure you have power entering the brake controller on the black wire. On the red wire you will only want power when the brake pedal is pressed.
If there is power on the red wire before the brake pedal is pressed you have connected the red wire from the brake controller to the wrong circuit. You would then need to find the brake switch wire that has power ONLY when the brake pedal is activated.
If these connections check out and the brake controller is properly grounded then there is possibly a problem inside the brake controller.
I am including a link to a video that will show you how to test the wiring on a brake controller.
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Primus IQ Trailer Brake Controller - 1 to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- LED Display
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement Master Cylinder And Shock For UFP A-60 / A-75 / XR-84 Surge Brake Actuators
- Q&A: 7-Pin Wiring Harness And Brake Controller For A 2024 Hyundai Santa Cruz
- Article: Trailer Maintenance Schedule
- Q&A: Trailer Hitch Receiver and Wiring Harness For a 2024 Hyundai Santa Cruz
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: 7-Way Trailer Wiring Harness for 2024 Hyundai Santa Cruz
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Which Wiring Harness Fits 2024 Hyundai Santa Cruz With Tow Package
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Installing ETBC7 Kit On 2004 Toyota Tacoma TRD V6