What is the Best Way to Cut an Oval Hole in a Trailer Frame to Install a Backup Light
Question:
What is the procedure to cut the holes in the frame of the trailer? On my gooseneck flat bed trailer, I would have to penetrate the web of a 6inch channel iron to install the grommet mounted 4inch round lights, on my horse trailer it would be aluminum that I would have to penetrate to install grommet mounted 6inch oblong lights. This would let them match the existing light on the trailer.
asked by: Dan T
Expert Reply:
To cut an oval hole in a trailer for a light such as # BUL22CB what works well is a hole saw. You can drill a few holes, one after the other and then trim and shape the hole for the grommet and light to fit in using a cutting tool of your choice such as a powered rotary tool with a cutting wheel.
For hole saw drill bits you would want to go with something that has a smaller diameter than the height needed for the light. This is because you can always make a hole larger but if you cut it too large you would have to patch up the hole some by welding on new steel and start again.
Product Page this Question was Asked From
Optronics LED Backup Light for Trucks or Trailers - Submersible - 27 Diodes - Oval - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2-5/16W Inch
- White
- Optronics
more information >
Continue Researching
- Shop: Premium Slim LED Strip Light - Weatherproof - 3,638 Lumens - 60" Long - Expandable
- Shop: Slim LED Strip Light - Weatherproof - 1,548 Lumens - 60" Long - Expandable
- Shop: Premium Slim LED Strip Light - Weatherproof - 3,000 Lumens - 47-1/2" Long
- Shop: LED Light Strip for Thule RV Awnings - Waterproof - 13' Long
- Shop: Optronics Flexible LED Light Strip - Weatherproof - White - 17' Long
- Shop: Mounting Clips for TecNiq Slim LED Strip Light - Flat Mount - Qty 2
- Shop: Premium Slim LED Strip Light - Weatherproof - 300 Lumens - 7" Long
- Q&A: How to Cut a Grommet Hole for Installation of the Oval Trailer Tail Lights # STL22RB
- Search Results: identification light bar
- Search Results: rubber trailer mats
- Search Results: tecniq
- Q&A: Hopkins 7-Way Trailer Connector to Older Featherlite Wiring Recommendation
- Article: Trailer Wiring Diagrams
- Search Results: 44649
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 68149
- Video: Choosing the Right Trailer Wiring
- Q&A: How to Read the Lippert Components Axle Description Measurements
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Article: Most Popular Wheel Bearings
- Search Results: 25580
- Shop: Brake Controller
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: dust cap
- Shop: Fifth Wheel Hitch
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome