Do the Lippert Underchassis Double Bin Storage Units Come with Locks

Question

Question:

Do the boxes or the sliding mechanism have a lock?

asked by: Jim H

0

Expert Reply:

The Lippert Underchassis Double Bin Storage Unit # LC175180 has spring loaded pull pins to hold the unit in place but no locks on it or the lids. There isn't really a good way to look these boxes unless you were to drill holes for a padlock. But there are no specific locks or method of locking these boxes.

expert reply by: Michael H

0

Answer 1

There aren't specific instructions for flush mounting E-track such as #E19148 but as long as the openings on top are clear and there is space enough below the holes to insert/remove accessories then it can be flush mounted or recessed some. It is…

view full answer...

Answer 2

The Lippert Underchassis Double Bin Storage Unit for RV #LC175180 is a simple bolt-on installation, no welding is going to be required as the steel frame of the unit will bolt onto your RV's frame. The storage unit is a total of 96" long x…

view full answer...

Answer 3

I could not find any installation videos on our site or Lippert's for the #LC175180 storage unit. Yes the frame brackets are welded in place. I am not sure what your 171.25 number is, but this storage bin solution will work with most 7 to 8 foot…

view full answer...

Answer 4

I have three different under trailer storage compartments for you depending on the width of your trailer. To determine which storage compartment is correct for you, you will want to take a tape measure and measure the distance between the spring…

view full answer...

Answer 5

The Lippert Underchassis Double Bin Storage Unit #LC175180 does not come with the mounting hardware. It does, however, list out the hardware in the installation instructions as you mentioned. This includes the following: 2 - 1/4" x 1 1/2"…

view full answer...

Answer 6

In order for something to be considered water tight or water proof it has to be able to be submerged and not leak any water. The Lippert Underchassis Double Bin Storage Unit #LC175180 that you referenced would keep things mostly dry under normal…

view full answer...

Answer 7

The E-Track part #E19148 that you referenced is not designed for a recess mount although if you wanted to come up with a way to do that you certainly could. There aren't specific instructions for flush mounting E-track such as #E19148 but as long…

view full answer...

Answer 8

While you can absolutely drive on the Erickson Horizontal E-Track #E19148 the track is far more likely to last long term if you have it recess-mounted or you have it installed so that the track is just to the side of your SUV's tires. Then for…

view full answer...

Answer 9

Installing the E-Track system to your enclosed trailers upright frame is a good idea for the strongest mounting location and cutting the plywood out to fit around the E-Track would not be an issue that I can see as long as the plywood sides have…

view full answer...

Answer 10

I didn't receive your photos, but the manner in which you attach the e-track to your trailer deck will completely depend on what the deck is constructed of and where exactly on the deck you'll be placing the e-track. Without knowing any…

view full answer...

Answer 11

In order to achieve the full capacity of the ratchet straps and the track, the direction of the pull should be parallel to the direction that the e track is running. How much the capacity would be diminished by pulling 90 degrees to the side will…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Do the Lippert Underchassis Double Bin Storage Units Come with Locks

Product Page this Question was Asked From

Continue Researching