Filter Products
Filter Results
$43.91 - $394.25
$16.86 - $16.86
Filter by Step Style
$43.91 - $394.25
$16.86 - $16.86
Videos
for Trailer Steps
Help Articles
for Trailer Steps
Expert Answers
for Trailer Steps
This is a known issue, as the trailer running lamp circuit on the 2019 GM trucks doesn't send enough voltage to power the camera system. The folks at ASA Electronics recently came out with an adapter, part #VGR64VR that splices in behind…
view full answer...I contacted Polar and they were reluctant to give me a weight rating for the step part #PLR900 however they were adamant about the fact that it can handle 210 lbs of weight. The step is designed to be used on industrial equipment so it is made of a…
view full answer...The Timbren Axle Less Kit part #ASR2KHDS03 that you referenced is essentially a 2,000 lb axle so it would take two of them for a 4,000 lb trailer. If you have a 4,000 lb trailer axle the most similar option that would work well you'd want…
view full answer...The etrailer Enclosed Trailer Transition Plate #e32JR will work very well for loading and unloading motorcycles. It has a working load limit of 1,000 lbs so even with your 850 lb bike, you are well within parameters weight capacity wise. Especially…
view full answer...In regards to the etrailer Enclosed Trailer Transition Plate #e32JR, the end plates are not designed to be swapped. There are pre-drilled holes in the end plates and center plates, which would not line up correctly if the end plates were swapped.…
view full answer...The service plan for the Galeo Pro part #GA94FR is offered in three time frames currently: Monthly/yearly/3-year service available from Galeo at $1.99/$19.99/$49.99.
view full answer...I recommend looking at the Equal-i-zer Weight Dist Shank - 18" Long - 8" Rise, 4" Drop - 600 to 1,400 lbs TW #EQ90-02-4600. This is 18" long and has a max tongue weight of 1,400lbs, whereas the Equal-i-zer Weight Dist Shank -…
view full answer...The Replacement Lens for RVPL5A and RVPL7A Lights #APL5AB is meant to be an exact replacement for the Optronics porch lights #RVPL5A and #RVPL7A as the title suggests. Although I cannot confirm if it would fit on the part number that you referenced,…
view full answer...Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…
view full answer...Pulling cars onto a trailer will undoubtedly require pulling the vehicle up an incline, which will add extra resistance to the equation. If you are pulling a rolling load, not dragging the car and no flat tires, up just a slight incline like a 3…
view full answer...The Atwood GE16EXT 10 gallon water heater has 23.5" x 19.4" x 18.2" dimensions so you'll have to make alterations to the cutout hole to fill in the gap from any of the water heaters we carry. I recommend the Furrion RV Tankless…
view full answer...For your Sure Trac ST9614 HLODOD-B-140 trailer I recommend adding the Ultra-Fab Ultra Scissor Jacks - 24" Lift - 6,500 lbs - Qty 2 #UF48-979002. I believe these will work well to stabilize your trailer for loading. They can be adjusted using the…
view full answer...