Can The End Plates On The etrailer Enclosed Trailer Transition Plate e32JR Be Swapped

Question

Question:

Can the e32JR Transition Plate end platesinch be swapped side for side to place the hinges closer to the center to provide more support to the center plate? Thanks for the help.

asked by: Larry

1

Helpful Expert Reply:

In regards to the etrailer Enclosed Trailer Transition Plate # e32JR, the end plates are not designed to be swapped. There are pre-drilled holes in the end plates and center plates, which would not line up correctly if the end plates were swapped. Also the placement of the hinge may obstruct the center plate. So there is going to be a designated passenger and driver side plate.

That being said, the center plate will have plenty of support, even with the transition plate in its widest adjustment. There is really no need to alter anything to add support. No matter what you do, you will still be limited to the 1,000 lb WLL.

expert reply by: Jesse M

1

Answer 1

The etrailer Enclosed Trailer Transition Plate #e32JR will work very well for loading and unloading motorcycles. It has a working load limit of 1,000 lbs so even with your 850 lb bike, you are well within parameters weight capacity wise. Especially…

view full answer...

Answer 2

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

view full answer...

Answer 3

The etrailer Enclosed Trailer Transition Plate #e32JR is adjustable in width and has a width range of 4 foot to 8-1/2 foot overall.

view full answer...

Answer 4

In regards to the etrailer Enclosed Trailer Transition Plate #e32JR, the end plates are not designed to be swapped. There are pre-drilled holes in the end plates and center plates, which would not line up correctly if the end plates were swapped.…

view full answer...

Answer 5

Hey Scott you will need to get the width of your ramp as well as the weight of the ramp to pick out what you'd need. For example the part #M394FR is for 8 foot wide ramps and has a weight capacity of 185 lb. I attached a link to all of the…

view full answer...

Answer 6

I do see the 2024 Ford Transit 350 is unchanged from the 2023 model year so there should be no reason the SumoSprings Solo Custom Helper Springs #SSR-121-54. When I reached out to SumoSprings they have not yet been able to verify fitment yet as they…

view full answer...

Answer 7

I verified with the manufacturer for you that the thickness of the RV Vinyl Flooring - Diamond Pattern - 24' Long x 8'2" Wide Strip - Black #TS89FR is .075 inches

view full answer...

Answer 8

Hey Lou, so the install of the Conventional Ramp Door Spring part #362SA7218 is something that should be done by someone who has experience winding garage springs. The amount of turns or preload will be the amount that gives you the correct amount of…

view full answer...

Answer 9

To test the weight of your ramp door, you will want to get the door all the way down to the ground and then on a scale of some kind (a bathroom scale can be used for this if it's the only thing available). This will be when the door is at its…

view full answer...

Answer 10

To determine the correct weight springs you will need a scale to determine how much weight is on the door when it lays out on the ground. You will place the scale on the ground in the center of the landing path of the door edge. This will tell you…

view full answer...

Can The End Plates On The etrailer Enclosed Trailer Transition Plate e32JR Be Swapped

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching