Videos
for Trailer Jack
Help Articles
for Trailer Jack
Expert Answers
for Trailer Jack
Here is an image I have from the Xtreme Off-Road Swing-Up Trailer Jack #ORJW750D in zinc which will have the same dimensions as the black Jack #ORJW750BD you are looking at.
view full answer...The Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels, #ORJW350D has an overall length of 18".
view full answer...Yes, the Extreme Off-Road Swing-Up Jack w/ Dual Wheels iItem #ORJW500D will work for your T@B 400 Tear Drop Trailer. It looks like your trailer comes with an a-frame jack. You would need to ensure you have enough space on your tongue to accommodate…
view full answer...There are some Dutton-Lainson trailer jacks that are made in the USA as well as a few that are not. Any jacks that we carry that are made in the USA have that as part of the description to help set them apart. Currently we have the following…
view full answer...The 235/80R16 size tire, like the Karrier ST235/80R16 Radial Trailer Tire #AM34903, will measure about 30.8" for overall diameter and have a section width of 9.25". This tire/wheel combo has an 8 on 6-1/2" bolt pattern. If…
view full answer...Good news! I was able to get a exploded diagram as well as a set of instructions on how to replace the rod and gears #TJD-12000-RODNUT in the #12000 Series Ram Jacks made after 2012. I have attached them to this page for your convenience.…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...It sounds like you're saying it is hooked up to power but it doesn't have the ability to raise the trailer. This could be the batteries or a problem with the wiring. It is probably getting power, it just may not be enough to lift the…
view full answer...When fully retracted, or collapsed the jack is 28.58 inches tall, and 38.42 inches tall when extended as shown in the provided diagram. I've linked you to a product description video featuring the #ORJW1SU ARK Extreme Off-Road Ratcheting…
view full answer...I have good news, our trailer jack that has a 2 inch outer diameter part #DL74MR would fit and work well. While it has a 1,000 lb weight capacity that does not mean 1,000 lb total trailer weight capacity. That capacity is the tongue weight capacity…
view full answer...I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…
view full answer...I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm…
view full answer...