Hi Kat, The rubber bumpers that we offer are all 96" in length but can come in different widths. Based on the dimensions you provided i your pictures the #D3-96 is going to be the best…

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The 235/80R16 size tire, like the Karrier ST235/80R16 Radial Trailer Tire #AM34903, will measure about 30.8" for overall diameter and have a section width of…

The etrailer Enclosed Trailer Transition Plate #e32JR is the only transition plate we carry and it does have a working load limit of 1,000 lbs. We have tested this transition plate extensively, and have found that it holds up well, even when…

If you already have a seal that you're replacing then you want to get a seal that's a similar size, otherwise if…

The closest thing we have to a 2" x 2" bumper is the Rubber Bumper for Enclosed Trailer Ramp Door #37210715 you looked at. This has a…

I recommend using the 601 Flooring Adhesive in a 1 Gallon #TS76FR or 4 Gallon #TS26FR depending on your application. The 601 does not have the pressure sensitive requirements of the 801, 1 Gallon #TS86FR and 4 Gallon #TS58FR adhesives.

A 3/8" self tapping screw seems a bit large for the Horse Trailer Side Pads #HTP1260BK but I do recommend always using a washer like the…

Hi Larry, So we have a couple bumpers that may work, though each is 96 inches long. They can be cut to length though, and the difference is their width, as one is 3" wide and the other…

Hey Philip so while we don't carry the exact spring you are looking for it does match the specs of the #e59SR so this would be a great solution.…

The bumper part #D3-96 that you referenced is our best option and could work for you but you will need to make some modifications. You would need to cut it down to the 84 inch length you need and would also need to drill new holes in it that line…