Filter Products
Filter Results
$53.75 - $109.08
$24.60 - $24.60
Filter by Battery
$53.75 - $109.08
$24.60 - $24.60
Videos
for Trailer Breakaway Kit
Help Articles
for Trailer Breakaway Kit
Expert Answers
for Trailer Breakaway Kit
On this page (typically below the product links) there is a helpful link section that will have the install instructions fo the Hopkins Breakaway kit part #20400 that you referenced. I also attached an install video that shows the kit installed as…
view full answer...Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…
view full answer...That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire…
view full answer...The lid of the Bright Way Trailer Breakaway ICU Kit with 12V, 5-Amp-Hour Battery, Charger, and Wire Loom #BW94FR that you referenced has a wiring diagram shown that details how it wires. Not seen is there is a single wire that runs up to running…
view full answer...Some different brand names of trailer breakaway kits do originate from a common source, and this is also true for items like jacks, landing gear and steps. There really is not a lot to distinguish one from another, since their component parts are…
view full answer...We do have a breakaway kit available for your triple axle trailer with 6 brakes; for your trailer, I recommend the Curt Soft Trac I Trailer Breakaway Kit with Battery Charger #C52040. This kit will work with 1, 2, 3 axle trailers.
view full answer...To charge the battery in the Engager Trailer BreakAway Kit, #20099, you can attach the wire from the 12 volt circuit on the trailer side 7-Way (1 oclock position on the back of the trailer side 7-Way where the wires attach) to the input wire on the…
view full answer...I have attached the installation instructions for the Hopkins Engager Trailer BreakAway Kit, part #20099. This kit includes a charger and an LED tester and will work with single and tandem axle trailers. I have also attached a link to an…
view full answer...If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…
view full answer...We do offer a replacement battery box with LED lid for the Hopkins Engager Breakaway box. The part number for the box and lid is #HM20121 and the part number for the battery itself is #HM20008.
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…
view full answer...