Videos
for RV TV Mount
Help Articles
for RV TV Mount
Expert Answers
for RV TV Mount
Yes, the lid is available as a replacement part. Based on the part numbers you gave me the correct replacement lid is the #FVK1020-19. For the lift arm you can use the #FVK8011-05.
view full answer...Hey David; I checked directly with Pace Edwards for you and can tell you that the rails on the Pace Edwards Switchblade Retractable Hard Tonneau Cover #PE46QJ will protrude just under 3/4" on both sides when installed on…
view full answer...The best replacement option for your 36.5" wide x 16" tall cutout hole is going to be the Furrion Electric RV Fireplace with Crystals #FF40SC15ABL. This unit would have to be…
view full answer...The MORryde Wall RV TV Mount #MR23ZR has dimensions of 5.25" W x 5.83" T for the plate that attaches to the wall. The MORryde Wall RV TV Mount #MR65ZR has dimensions of 10" W…
view full answer...While there isn't a locking pin for the lower portion of the EcoHitch Stealth Trailer Hitch Receiver #EH84GR the good news is this won't be a high-theft item at all for a few reasons. Most people would…
view full answer...Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…
view full answer...I checked the install manual for the MORryde Wall RV TV Mount part #MR82ZR and there were no stipulations for mounting orientation but the location of the handle will change if you choose to mount it so it slides out to the left. That said, you…
view full answer...Yes, the MORryde Wall RV TV Mount - Fixed item #MR28ZR has a lot of movement in it based on how you have to install it. I have linked a video and if you watch it around the 1:44 mark you will see how the top connection point between the wall mount…
view full answer...I was able to get ahold of MORRyde for their technical drawings of the MORryde Ceiling RV TV Mount - Flip Down - Full Motion #MR24RR, and through that I was able to get some useful dimensions for you. This mount has an overall height of…
view full answer...The Curt Trailer Hitch Receiver #C13394 will fit with a full size spare tire stowed under vehicle unless the spare is on an aluminum rim, which is too wide. If you're concerned about the fit of the hitch with your spare tire I…
view full answer...The weight of the Pace Edwards Switchblade #PE66QJ is 68 pounds. As far as as your question about the height of the cover installed on the side rails, it sits just shy of 1/8 of an inch. With this measurement, it truly depends on the height of your…
view full answer...The Dexter Trailer Brake Assemblies 023-476-00 will cross-reference to our Dexter Electric Trailer Brake Kit part #K23-472-473-00.
view full answer...