Filter Products
Filter by Style of Furniture
$769.33 - $769.33
Videos
for RV Couches and Chairs
Help Articles
for RV Couches and Chairs
Expert Answers
for RV Couches and Chairs
You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…
view full answer...Try removing the good working cupholder and installing it on the side that isn't working. Most likely that will fix the issue and indicates that you need a new cupholder like with the part #195-387597 that you referenced.
view full answer...If you check out the picture I attached you can see that when the Stromberg Carlson Bunk Adapter part #CC-255 is installed you still have really great access to the propane tanks of the RV.
view full answer...The Carr LD Custom Fit Side Steps #CARR114501 are a great option for adding steps to your 2008 Toyota Tundra, but these are meant to be installed onto the rocker panels underneath your vehicle. They cannot be added to your existing running boards,…
view full answer...I spoke with my contact at Lippert who said that either the heater is bad or the control box needs to be replaced on your Thomas Payne Momentum recliner. To test the heater unplug the red and black wires from the control box (located behind and…
view full answer...I do have suspension enhancement options for a 2002 Workhorse P42 Chassis but there are no air bags available unfortunately. Instead, you can use the Timbren Rear Suspension Enhancement System. The correct one will be based off the suspension. The…
view full answer...The support capacity of the scissor jacks are for each jack individually. So the part #UF48-979031 comes with two jacks that are each rated for 6,500 lbs. So you'd multiply that by how many jacks you end up using
view full answer...For your Class A Motorhome you are probably going to want to use the Ultra-Fab Ultra Scissor Jacks part #UF48-979031 instead of the Ultra-Fab Ultra Scissor Jacks part #UF48-979002 as they offer more lift which will be needed. They are designed…
view full answer...To flat tow your Ram 2500, you'll need a tow bar, base plates, safety cables, a wiring solution, a supplemental braking system and possibly a high/low adapter. I really like the equipment offered by Roadmaster, the quality and ease of use…
view full answer...You'll need a taillight converter to combine the right turn, left turn and brake lamp signals into two circuits (right turn/brake and left turn/brake) for the trailer. First, I'd remove the existing 6 pin square connector on the RV,…
view full answer...The 6-Way square trailer connector is not used by a lot of trailer manufacturers. A lot of Jayco trailers may have them but mostly you come across the 4-Way flat, like what you have on your trailer, and the 7-Way blade for RV applications. What I…
view full answer...To install a brake controller in your 2003 Monaco Windsor built on a Roadmaster chassis you will need to hardwire it. I attached an FAQ on how this would be done. Basically you will need to run the blue wire from the controller back to your 6-way.…
view full answer...