Does Install of Stromberg Carlson Bunk Tray Adapter # CC-255 Allow Access to Propane Tanks

Question

Question:

Are there any modifications I can do to my Stromberg Carlson Trailer Tray so I can quickly remove it for access when I want to refill my propane tanks?

asked by: Tony

0

Expert Reply:

If you check out the picture I attached you can see that when the Stromberg Carlson Bunk Adapter part # CC-255 is installed you still have really great access to the propane tanks of the RV.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Yes, we can ship the Space Dock 2" Receiver Adapter for Torklift Palomino Landing Pad Bumper part #TLA7900 to you in Canada! However, the quoted shipping costs does not include all brokerage fees and duties. Taxes are not included and all…

view full answer...

Answer 2

The height of the Stromberg Carlson Trailer Tray Cargo Carrier part #CC-255 can be adjusted by trimming the c-channel tubes. Unfortunately, I cannot provide the minimum height as this will all be dependent on how much material is taken off but we…

view full answer...

Answer 3

It might make it a little more involved to get to the LP tanks, but the Stromberg Carlson Trailer Tray Cargo Carrier #CC-255 would only provide a slight interference if any at all. Basically, like the pictures indicate there will be a tray several…

view full answer...

Answer 4

I see how that might be troublesome; anytime you have a large canoe on a roof rack it can be difficult to set it up to where it doesn't make contact with the vehicle's roof. I don't see any other canoe carriers that would elevate the…

view full answer...

Answer 5

It would probably be much easier to fill tanks with the Stromberg Carlson Trailer Tray Cargo Carrier #CC-255 if you had a soft cover on the tanks instead of a hard cover.

view full answer...

Answer 6

I don't think you'd have any issue removing your propane covers with the #CC-255 installed. If you check out the pictures I attached you'll see this installed on a trailer that has the white version of your cover installed. In the last…

view full answer...

Answer 7

If you can't place any weight on the trailer in any way that limits a lot of the options. Basically you'd have to decide if you could fit in in the interior or use a bunk like part #CC-255 as a platform on the tongue of the trailer. This is…

view full answer...

Answer 8

The Stromberg Carlson Trailer Tray Cargo Carrier for A-Frame Trailers, #CC-255 has about a 29" clearance from the top of the trailer frame at its mount point to the cargo tray. A 30 lb. propane tank measures approximately 24" in height so…

view full answer...

Answer 9

The Stromberg Bunk Adapter part #CC-255 is a great solution for what you are looking for. This attaches to the frame members of your camper and gives you a platform up above the propane tanks to carry a generator. I attached a picture of this…

view full answer...

Answer 10

I may have an option for you but It is not a good idea to cut the tongue of the camper and elongate it. It will affect the structural integrity and the tongue weight of the trailer especially if you add a generator to the tongue. It sounds like you…

view full answer...

Answer 11

It will be a close fit but your 18" x 25" generator will fit on the tray of the Stromberg Carlson Trailer Tray Cargo Carrier #CC-255. If you look at the linked photo you can see that the very front of the tray measures 24-3/4" long,…

view full answer...

Answer 12

Yes, you can leave your generator mounted on the Stromberg Carlson Trailer Tray Cargo Carrier #CC-255 while you are using it! I would just be sure to mount the generator in such a way that the exhaust isn't pointing towards anything while in…

view full answer...

Does Install of Stromberg Carlson Bunk Tray Adapter # CC-255 Allow Access to Propane Tanks

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching