Thanks for the picture! For your 2023 GMC Sierra 1500 with adaptive ride control you'll want the Air Lift LoadLifter 5000 Air Helper Springs item #AL57388. This air bags have a 5,000 lbs load leveling capacity that will keep the rear end of…

The Firestone In-Cab Pressure Gauge #F2196 will work with the AirLift systems. If you can tell me the part number of which AirLift kit you have I can try and help you with that system if you'd like.

Based on the GVWR of your 2019 Jayco North Point 315RLTS it does seem like you have 7k axles. I recommend verifying this information to be sure. These axles typically use the #14125A outer and #25580 inner bearing found in the Timken #TMK92VR.…

Thanks for reaching out, Randy! It sounds like you're looking for something like the In-Cab Air Pressure Monitoring Gauge #F2196 which is a generic kit that can tie-in on the output side of your tank. Any gauge that comes with an air pressure kit…

The socket needed for the Fastway e2 is the 1-7/8" 12pt Thin Walled Socket #ALL643216.

Both the Air Lift LoadLifter 5000 Air Helper Springs #AL57234 and Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88234 are a fit for your 2019 Ford Ranger, and the difference between the two is really only what…

I would be happy to! Weight distribution systems are selected based off of tongue weight which is typically between 10% - 15% of your trailer's total weight. This would put yours between 250 lbs - 375 lbs. There's really only a couple of…

Hey Nate, the Firestone Ride-Rite #F2609 will indeed fit the 2023 GMC 1500 Denali with the adaptive ride control from the factory. As of right now (March 2024), the #F2609 kit is actually the only kit known to be compatible with the adaptive ride…

Yep! The 1-7/8" 12pt Thin Walled Socket #ALL643216 does work with the e2 Fastway round bar weight distribution systems. This socket costs considerably less than the Equal-i-zer socket and works just as well so it's what we normally…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

All of the brake hoses, including the main brake line, are made of rubber on the 20 foot Kodiak Hydraulic Brake Line Kit - Tandem Axle #20TA-BLKIT. The hoses on the #20TA-BLKIT also have brass fittings with stainless steel flares.

Mixing and matching the brackets and air springs isn't really recommended but you might be able to get a combination to work. If I were you I would just put the complete #AL88288 kit on since that would fit properly and there wouldn't be any…