Filter Results
$153.21 - $153.21
$111.90 - $111.90
Videos
for Folding Trailer Tongue
Help Articles
for Folding Trailer Tongue
Expert Answers
for Folding Trailer Tongue
Oddly enough I can't find a decent u-bolt that we carry that would work well for your application.
view full answer...I have a solution for you but the part #CE10190GA-4 is not available in a half kit so what you would want is the part #CE10190GA with the swivel bracket part #CE10206G. We don't have the bolt and nut though so you would need to supply that…
view full answer...For your aluminum trailer with a galvanized steel tongue (swing-away tongues cannot be used on aluminum tongues), you'll need a die-cast steel tongue with a zinc finish from Fulton. The correct fit is going to depend on the size of your…
view full answer...We have a folding trailer tongue hinge that could work for the purpose you describe, as long as your trailer frame isn't constructed of aluminum. You could use the Fulton Fold Away Coupler Hinge, part #FHDPW330300. The hinge kit is designed…
view full answer...For your application there really is only going to be a weld on solution that's reasonable like the part #UF48-979022 that you referenced. The frame dimensions are unknown so a weld solution would be better since that really doesn't matter.…
view full answer...The Dexter Zinc-Plated Brake Actuator #T47457007K does not have an access hole to insert a screwdriver to bleed the master cylinder. You will have to use the old method with a 2x4 and the safety chains. While the trailer is disconnected from the…
view full answer...We can definitely help set you up with a tow package for your 2024 Kia Telluride. The main components you will need are a hitch, 7-way wiring harness, and a brake controller. You will need a good ball mount too, but it sounds like you have that…
view full answer...The overall length of the Fulton hinge kit part #FHDPW330300 is 7-1/2 inches. You should note that since this slips over the frame channels it does not add this length to the tongue of the trailer.
view full answer...Thank you for all of the photos and information! From what I can see it looks like you have a #84 spindle but that inner bearing blew out so you should be able to remove that inner sleeve that looks like it's still on the spindle (next to where…
view full answer...All of the needed install hardware for the Fulton Hinge Kit part #FHDPB230101 that you referenced comes with the kit. You would not need to provide your own.
view full answer...In order to install a Fulton Fold-Away Coupler Hinge Kit like part #FHDPB230101 on a trailer with surge brakes you are going to want to use a flexible brake line that runs from the actuator to the t-fitting just before it splits to each braking…
view full answer...The length of the fold away can be shortened in most circumstances. If you have a 3 x 5 inch trailer tongue then the Fulton Fold-Away Coupler Hinge Kit, item #FHDPB350101, can be used and the extension out front can be cut to any length shorter than…
view full answer...