Videos
for Emergency Vehicle Lights
Help Articles
for Emergency Vehicle Lights
Expert Answers
for Emergency Vehicle Lights
What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…
view full answer...The Demco Hijacker Autoslide 21K #DM8550038 weighs approximately 305-lbs. The head of this hitch weighs around 70-lbs and can be removed to help make moving and installing this 5th wheel hitch a little bit easier.
view full answer...Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to…
view full answer...Blue Ox has base plate kits that fit your 2023 GMC Yukon XL with the part #BLU54VR which fits the AT4 models with 4L and the part #BLU58FR which fits the non-AT4 models. While we haven't had the chance to shoot an install video for either of…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Yes we have a 14 inch version of the Aluminum Viking Series Valhalla trailer wheel with the part #AX02455545BMFL. This is 5-1/2 inches wide and has the standard 5 on 4-1/2 inch bolt pattern that 14 inch trailer wheels have. I attached a picture of…
view full answer...You can use a 7-Way and 4-Way connector at the same time just as long as you are not overloading the light circuits. If your camper has a lot of outside lights like running lights, and brake/stop/turn lights then the lights that perform the same…
view full answer...The longest extension available that will work with the factory trailer hitch receiver on your 2019 Chevrolet Silverado 1500 is the Draw-Tite Hitch Extender for 2" Hitch Receivers - 18" Long #HE18. You will need to measure from the center…
view full answer...There is a Titan hitch extender that should work for you, but would require a Titan hitch be installed on your truck to handle a tongue weight loaded that far from the hitch. It is Reese part #RP45292. You can use it as a 34 inch extension or cut it…
view full answer...The Grease Seal part #168233 has a double lip so it can be used on a boat trailer and be submersed under water, yes. This is also the correct replacement for the NOK AD2527E Grease Seal that you have now.
view full answer...If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
view full answer...