Trailer Brake Controller Specs:
Features:
Mount the control knob of this proportional brake controller on your dash for a factory look, and install the main unit out of sight behind the dash. Control your braking power with the turn of a dial, with manual override right at your fingertips.
Installation Notes:
The brake controller can easily be installed with the included vehicle specific wiring adapter; no other parts are necessary.
More Information >Trailer Brake Controller Specs:
Features:
Mount the control knob of this proportional brake controller on your dash for a factory look, and install the main unit out of sight behind the dash. Control your braking power with the turn of a dial, with manual override right at your fingertips.
Installation Notes:
You will also need item 37185 ($55.30) to complete your wiring.
The brake controller can easily be installed with the included vehicle specific wiring adapter; no other parts are necessary.
More Information >Videos
for Trailer Brake Controller
Help Articles
for Trailer Brake Controller
Expert Answers
for Trailer Brake Controller
Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…
view full answer...If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you…
view full answer...All the brake controller needs to sense a trailer connection so that you can test it is a slight amperage draw on the output circuit. For that you can use a circuit tester like the part #PTW2993 with one pin grounded and the other on the output…
view full answer...For your 2024 Nissan Frontier I recommend the Redarc Tow-Pro Liberty Brake Controller #RED24FR. I like the Liberty because it is simple, reliable, and looks great in any vehicle. The main unit installs behind the dash, so only the control knob will…
view full answer...For your 2024 Chevy Silverado 1500 I recommend the Redarc Tow Pro Elite #RED63RR. You can use it along with the Plug in Adapter #3064-P for a plug and play install, since you already have the factory tow package. The Redarc controller is going to…
view full answer...The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…
view full answer...You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…
view full answer...A factory 7-way trailer connector…
view full answer...Filter Products (4)
Contact and Help
What our customers are saying:
Excellent service and communication. Expect part to be excellent too!
Tommy
Tifton, GA