We have replacement 7-ways that fit your 2017 Toyota 4Runner but the one you mentioned does not fit. So instead you'd want the # A10-7072VP which will plug right into the round connector you have at the rear of your vehicle and give you a new 7-way. view full answer...
We don't carry any aftermarket bumpers for your 4Runner but that is the route I recommend. The reason is that adding a bull bar or a grille guard will interfere with the mounting locations of baseplates, so you can't have both. If you get a heavy duty front bumper with D-rings then you can use those as your baseplates using your Blue Ox Tow Bar and the corresponding adapter:
-Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin # BX88357
-Blue Ox Aftermarket Bumper Adapter - 1" Pin... view full answer...
Yes, the frame brackets of the Fastway weight distribution system part # FA92-00-0600 will fit great on a 2 inch by 3 inch trailer frame. I also looked up the GVWR of your KZ RV Sportsmen Classic 181BH and this system would work in that regard as well. view full answer...
The Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # 33405 is designed to plug into a factory port on your vehicle. If the electrical system has been upgraded to 24 volts as it goes through the wiring harness it will degrade it to the standard 12 volts. So as comes out of the factory plug it will still be 12 volts at the factory plug so yes the harness will work. view full answer...
Yes, a Gobi rear ladder could still fit the back of your 2017 Toyota 4Runner with the Pioneer Platform Tray part # JA9965 installed as there's plenty of room. I attached a picture of this rack installed on a similar 4Runner and you can see there's clearance for the Gobi ladder which only attaches to the top of the rear hatch. view full answer...
The Yakima SkyRise HD part # Y07437 needs to attach to an aftermarket roof rack with top channels in like the Yakima JetStream roof rack part # Y00426 and # Y00147 that is a confirmed fit for the roof of your 2005 Toyota 4Runner with raised rails. view full answer...
An important thing to note with grille guards is that both the mounting brackets and the grille guard itself are vehicle specific. This unfortunately means that a grille guard that was designed for and mounted on a 2009 Toyota Tundra won't fit your 2004 4Runner even when using brackets specific to your vehicle.
Your only option is really to purchase a new grille guard that's designed for your 4Runner. For this the Westin Ultimate Bull Bar with Skid Plate in Black Powder Coated Steel #... view full answer...
It sounds like you already did this, but you will want to first measure your roof and determine which size roof basket will fit and not interfere with your antenna. Based on what you said, it looks like the Surco Safari Rack 5.0 Rooftop Cargo Basket for Factory Rails - 60" Long x 50" Wide # SPS5060-1101 would fit your roof and suit your needs. This basket is designed to work with factory raised rails, so if that is what you have on your roof then it will work well for you. In regard to... view full answer...
Thanks for the feedback, and I am glad that you are finding our website helpful!
For your 1989 Trailex CT-7031 all aluminum trailer with the specifications that you provided there are three options for restoring or replacing the brakes for this trailer. The three options are similar to what you mentioned, and are:
1.Hydraulic Drum, which is the most cost effective.
2.Hydraulic Disc, which is more expensive, but provides better performance.
3.Electric drum, which is most cost effective... view full answer...
The Draw Tite Hitch part # 75091 is confirmed to fit your 2001 Toyota 4Runner and we had a customer write in a review saying that this hitch installs without any interference with the factory spare tire.
The instructions for this product indicate that you might need to position the spare further forward, but that you would be able to retain the spare.
You will be able to keep your spare with this hitch. view full answer...
Fulton makes high quality winches like the Fulton Winch # F142201 that you referenced. JIF Marine makes great winches too and the Single-Speed Boat Trailer Winch # 315-W2000D is almost an identical design except for it comes with a 20 foot cable and a strap included. Based on that I would go with the JIF. view full answer...
I checked the owner's manual for the 2018 Toyota 4Runner and it states that you should not exceed 120lbs on the roof rack. Since the Thule Hullavator weighs 40lbs each and your kayaks weigh 49lbs each, you are looking at around 180lbs total which is too much.
Instead, I recommend going with Malone DownLoader Kayak Carrier and TelosXL Load Assist # MPG114MD-351XL. Then for your second kayak you will need to add another Malone Downloader Carrier # MPG114MD. This setup will allow you to... view full answer...
I suggest the Rhino-Rack Ski and Fishing Rod Carrier, depending on size needed either the # RR572, # RR573F, or the # RR576F . These are compatible with round, square, aero type, elliptical, and most factory crossbars with dimensions up to 3-1/2" wide and 1-1/2" tall. view full answer...
You are right on with my recommendation.
For rear suspension enhancement for your 2005 Toyota 4Runner towing a single axle Jayco camper weighing around 2750 unloaded the SumoSprings # SS78DR is what I recommend.
SumoSprings are a lot softer than other jounce style suspension enhancement so your unloaded ride will not be affected, but you will still get 1000lbs of load leveling support when towing your camper.
These are also maintenance free where air helper springs can leak air and require... view full answer...
For a 2018 Toyota 4Runner and Yakima LoadWarrior rack, my recommendation will be different depending on if you have the # Y07070 with 38-1/2 inch x 38-1/2 inch interior dimensions or # Y07070-74 with interior dimensions of 56-1/2 inch x 38-1/2 Inches.
The Rhino-Rack Rooftop Cargo Bag - Waterproof - 8.5 cu ft - 43" x 31-1/2" x 11-1/2" # RRLB250 or the Rightline Gear Sport 3 Rooftop Cargo Bag - Waterproof - 18 cu ft - 48" x 40" x 19" # RL100S30 are the two waterproof options I'd recommend.... view full answer...
Now if your trailer does not have brakes all you would need is the part # 37185 as an adapter to convert the 4-way to a 7-way.
If you do have trailer brakes you would need the # ETBC7 instead of the # 37185 and a brake controller. This kit comes with everything needed to wire up the 7-way and install a brake controller.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how... view full answer...
Yakima actually has a net specifically made for your Megawarrior Roof Rack # Y07080. It is the Stretch Net for Yakima MegaWarrior Roof Rack Cargo Basket # Y07081 which has upstretched dimensions of 45" long x 38" wide. This would be my first recommendation since it is made specifically for this fit.
If you are looking for other options, you may want to consider the following:
Curt Stretchable Cargo Net - 38" Wide x 44" Long # C18200
Spidy Gear Luggage Webb Cargo Net for SUVs, Vans,... view full answer...
An ideal solution for you would be to use a hitch mounted bike rack on your 2003 Toyota 4Runner that has a longer shank, so that your Yakima Holdup Bike Rack part # Y02443 will clear the spare. Another solution you have would be to use a hitch extender like part # HE06. This will provide you with 7 additional inches of clearance so that your bike rack would clear. However, when using this extension the capacity of your hitch tongue weight is cut in half. Please make sure that you still... view full answer...
The first thing you will want to do is measure to see how much clearance you have at the rear of your 2014 Toyota 4Runner. I have attached a helpful article that shows you how to take this measurement. The article says it is for bike racks but the same principal applies for hitch-mounted carriers.
I recommend the etrailer Cargo Carrier, part # e98874. This carrier fits 2 inch hitch receivers and measures 24 X 60, which is one of the largest cargo carriers we offer. This carrier has a shank... view full answer...
You are going to need two things before you can tow your new trailer and I would recommend you install them before you head down there.
First, to convert the 4-way of your 2002 4Runner to a 7-way and allow you to install a brake controller you will want the Universal Installation Kit for Trailer Brake Controller # ETBC7. I attached an install video and installation instructions for you to check out as well.
For a brake controller I would recommend the Prodigy P2 Brake Controller part... view full answer...
Go To Results