Expert Answers about Hummer

• Curt Trailer Hitch Mounted Spare Tire Carrier For 2004 Hummer H2
• The Curt Trailer Hitch Mounted Spare Tire Carrier # c31006 will hold your spare provided that the trailer hitch on the front of your vehicle is also capable of supporting the combined weight of the spare and the carrier. A 36 inch tires with stock h2 rims will be fine. Per Curt, the weight capacity of the carrier is whatever the tongue weight capacity of the trailer hitch is in this case. Included is a video resource to reference as well.
  view full answer...


• What Vehicles Will the Westin Oval Tube Steps w/ Custom Installation Kit 22-5050-1635 Fit
• The Westin Oval Tube Steps w/ Custom Installation Kit part # 22-5050-1635 will fit a 2006 - 2010 Hummer H3 but that's all. However, there are different install kits which allow you to use them on other vehicles as well.
  view full answer...


• Suspension Enhancement Kits for 2003 Hummer H2
• Firestone Level-Rite Air Helper Springs and Shock Absorber Kit F1003 does NOT fit your 2003 Hummer H2 but all suspension enhancement products for this vehicle can be seen on the linked page. The front axle kit we have comes from Timbren and it a set of rubber jounce springs designed to support your front suspension when it is under load, such as when using a snow plow on the vehicle, kit # TGMFK25S. This no-drill kits includes rubber springs that provide progressive resistance when under...
  view full answer...


• Will the thule Range 4-Bike Rack Extend Far Enough Past the Spare Tire on a Hummer H3
• The Yakima LongHaul 4-Bike RV Hitch Mounted Rack # Y02476, will fit on your Hummer H3 if the measurement from the center of your hitch pin hole to the furthest part of the spare tire is less than 9 inches. I have included review videos for this rack below. The hitch mounted, tilting 4 bike rack with the most clearance is the Folding 4 Bike Dual Arm Rack - Swagman Trailhead, # S63380. It measures 13 inches from the center of the hitch pin hole to the back of the upright bar. I have included...
  view full answer...


• Can I Install a RedArc Tow Pro Liberty on a 2008 Hummer H3
• Yes. You can install the RedArc Tow Pro Liberty # RED24FR on a 2008 Hummer H3 using the available wiring under the dash. There is not a plug in adapter on the 2008 H3, so you would need to hard-wire in the brake controller, but the wiring is present to make this installation fairly easy. You'll want to use butt connectors like the # DW05745-5 to make the connections to the existing wires and you can use one of your existing slots on the dash to install the knob that comes with the Liberty....
  view full answer...


• Will SportRack Swinging Bike Rack SR2415 Swing Out Far Enough on a Hummer H3
• My contact at SportRack tells me that they haven't come across any fit problems with the H3, but I'd recommend taking two measurements for confirmation. There are two possible clearance problems you could encounter, if the shank on the rack is long enough to allow the rack to be fully inserted into the receiver so the hitch pin holes line up, and if the rack will swing to the right far enough so that the rear door can be fully opened. For the first issue, you'd need to measure rearward...
  view full answer...


• What Two Bike Rack Is Recommended For A Hummer H3 And Will A Spare Tire Mount Bike Rack Work
• To make sure a hitch bike rack will work on your Hummer H3 you will need to measure to make sure the bike rack will clear your spare tire. If you measure from the center of your hitch pin hole to the farthest part on the back of your vehicle, which would be your spare tire, and that measures less than 11-1/2 inches then you could use the Swagman Dispatch Bike Rack # S44FR. I have included a link to instructions for the proper installation of this product. It has a weight capacity of 90...
  view full answer...


• Will GearDeck 17 Hitch Cargo Carrier Clear Spare Tire on 2006 Hummer H3
• To see if the GearDeck 17 Enclosed Cargo Carrier for 2" Hitches # H00604, will fit on your 2006 Hummer H3 with a spare tire on the back there are a few things you will need to check out on your hitch and your vehicle. The GearDeck, # H00604, can only be used on Class III and Class IV 2-inch hitches. So you will want to make sure you have a 2-inch hitch on your Hummer. Next, you will need to measure the distance from the center of your hitch pin hole to the farthest back part of your spare...
  view full answer...


• Towing Mirror Recommendation for a 2005 Hummer H2
• The 2005 Hummer H2 is related to the 2005 Chevy Tahoe and K Source mirrors # KS62075-76G do fit the Tahoe. But they are not a confirmed fit for the Hummer H2. None of the manufacturers we carry have a confirmed fit for the Hummer H2. The safe bet is to use a universal towing mirror. I have included a link to the universal mirrors that we carry to the right. The most popular option is # KS3891. I have linked a video showing how the universal mirror installs.
  view full answer...


• Can a Ladder Rack Be Installed on a 2007 Humvee
• I have a potential solution for you, but there aren't any custom fit ladder racks for a 2007 Humvee so we will be looking into "uncharted" territory for your setup. The only ladder rack that I can see possibly working for your application is the Yakima OverHaul HD when it comes with the track mount. The smallest configuration is with 54" tracks (that can be trimmed to length) and then you just need to choose the best crossbar width for your vehicle: - 60" Crossbar Kit # Y22AR - 68"...
  view full answer...


• Will the Curt Roof Mounted Cargo Basket Part # C18115-117 Fit a 2006 Hummer H2
• We have not yet tested the Curt Roof Mounted Cargo Basket part # C18115-117 on a 2006 Hummer H2 with a factory roof rack therefore, in order to determine compatibility you would need to do a bit of measuring on your Hummer. For starters, the Curt cargo basket works with crossbars that are spaced between 22 and 50 inches apart on center and do not exceed 3" wide x 1-5/8" tall. Therefore, as long as the factory roof rack on your H2 fits these two criteria then it will work well for you. Unfortunately,...
  view full answer...


• Compatiblility of Flash E Series Adjustable 2-Ball Mount with 2003 Hummer H2
• The Flash E Series Adjustable 2-Ball Mount, part # FA42-00-2800 will work just fine with a 2x2 inch Class III receiver on your Hummer H2. The Ball Mount has a 8000 lb capacity when used with the 2 inch ball, or 10,000 lbs when used with the 2-5/16 ball, although your maximum capacity will be limited by the manufacturers stated towing capacity.
  view full answer...


• Recommended Tekonsha Brake Controller Adapter for a 2003 Hummer H2
• To connect the Redarc Tow-Pro Elite item # RED63RR to your 2003 H2 you will need the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers item # 3015-P. This harness plugs directly into the Redarc wiring adapter that comes with item # RED63RR and also to the port underneath your Hummer H2's dash. The port is only available on the H2 models with the factory 7-Way and without the factory tow package.
  view full answer...


• What Are the Best Towing Mirrors That Fit My 2007 Hummer H3
• We do have a fit for your 2007 Hummer H3, but the CIPA Custom Towing Mirror - Slip On - Driver Side # CM11551 wil not fit. They actually only fit 2015-2019 Ford F-150. The towing mirrors I recommend are the CIPA Universal Towing Mirrors - Clamp On - Qty 2 # CM11980-2. These mirrors easily clamp onto your existing mirrors and are a fit for your 2007 Hummer H3. Another reason I recommend these is that they pivot 360 degrees to give you the view you need at all times.
  view full answer...


• Will the Yakima MegaWarrior Part # Y07080 Fit a 2009 Hummer H3 Alpha with Factory Roof Rack
• Yes, the Yakima MegaWarrior Extra Large Roof Rack Cargo Basket part # Y07080 will mount to the factory crossbars you have on your 2009 Hummer H3 Alpha without additional purchase necessary. We have not yet installed this cargo basket on a Hummer H3 so I would not be able to confirm if it covers the sunroof but if the sunroof is positioned between the two crossbars then you can assume it will cover it. It is also not recommend to open the sunroof with the basket attached as the noise would...
  view full answer...


• Demco Classic Base Plate with a Blue Ox Avail Tow Bar on a 2008 Hummer H3
• I called Demco on your behalf, and the Demco Classic Base Plate Kit, part # DM9518193, is indeed a good base plate for a 2008 Hummer H3 and, more importantly, compatible with your Blue Ox Avail Tow Bar, part # BX7420. According to them, no adapter is needed. Unfortunately, once you have installed this base plate, the hooks will have to stay off. At the point, the only way to mount your hooks back onto the Hummer is to uninstall the base plate and reinstall the hooks.
  view full answer...


• Availability of a Folding Cargo Carrier to Fit a 2006 Hummer H2
• You will be able to install the 20x60 Folding Cargo Carrier for 2 inch Trailer Hitches, item # C18151, in the receiver hitch of your 2006 Hummer H2 with no problems but you will need to measure to be sure the carrier will fold up once it is installed in the hitch. Measure from the center of your hitch pin hole to the farthest back part of the Hummer, whether it be the bumper or a rear mounted spare tire. If this measurement is less than 6 inches then the cargo carrier will fold up without...
  view full answer...


• Roof Cargo Bag Fit for Factory Roof Rack on 2008 Hummer H3
• The Rightline Gear Sport 3 Rooftop Cargo Bag - Waterproof - 18 cu ft - 48" x 40" x 19" # RL100S30 (18 cubic feet) will work well for your factory roof rack. This will attach to your factory roof rack to secure it or can be secured to the door jambs if preferred. The bag can fit over the rails so there isn't a minimum size. Considering the height of your H3, you might want to include the HitchMate TireStep # HE4040. This is a slip-on wheel mount step that makes accessing your cargo...
  view full answer...


• Hitch Pin to Fit 2 Inch Class III Trailer Hitch on a Hummer H3
• The hitch you ordered is the Draw-Tite # 75382 which is a 2 inch Class III receiver. For a standard hitch pin and clip use part # PC3. If you prefer a locking pin part # e98882 will fit the hitch. I've also linked our complete selection of ball mounts that fit. One I like to recommend is the B&W Tow & Stow, part # BWTS10037B. It's adjustable with two different ball sizes so it can be used with a large variety of trailers. It also flips under itself to a stored position to keep it...
  view full answer...