The trailer taillight part # 432200 would work well for you. It is designed for exactly what you are looking for. The additional functions that the light has are for the reflectors on the sides of the assemblies.
For the left hand side you would also want the # 432400.
I attached a help article on trailer wiring for you to check out as well. view full answer...
The easiest Class II, 1-1/4 inch trailer hitch receiver to install on your 2005 Dodge Caravan without Stow-N-Go seating is from Draw-Tite:
- Draw-Tite Trailer Hitch Receiver # 36296
The # 36296 is the easiest to install because it is does not require any drilling on your '05 Caravan, unlike the Curt Trailer Hitch # C12362 that also fits your '05 Caravan. So the Draw-Tite will definitely be the best hitch for you, and can absolutely be installed without a helper. I have added a link below... view full answer...
The high-low adapters are only for use with a motor home while towing another vehicle with a tow bar. They are not designed or intended for use while towing any trailer, cargo carrier, or bike rack. A safer option would be the Dual-purpose ball mount, part # D210, which will raise the hitch opening 4-3/4 inches. The Dual-purpose ball mount also has a ballmount below the receiver for towing and using an accessory at the same time.
The unit has a 7500 lb towing and 750 lb tongue weight... view full answer...
The # 63153 cargo carrier does not have any vehicle specific fits, but you can determine whether or not you will be able to open the hatch with the cargo carrier installed by taking some simple measurements.
This cargo carrier measures 12-3/4 inches from the center of the hitch pin hole to the upright rail of the cargo carrier, and the platform of the carrier will be raised up 2-1/2 inches from the top of the hitch opening. If you measure out and up from your trailer hitch, this would... view full answer...
The Curt Trailer Hitch # C12289 will in fact, fit your 2005 Dodge Caravan SE. The hitch will not interfere with any of the vans VMI modifications as it does not get close enough to the rear axle. Additionally, when the hitch it fully installed it is approximately 12 1/4 inches from the top of the receiver tube opening, to the ground giving you plenty of clearance. To fully ensure that our product will fit your vehicle, it would be a good idea and check the instructions and get underneath... view full answer...
Yes, the T-One harness part # 118300 that you referenced is a confirmed fit for your 2006 Dodge Caravan with or without the stow away seat. view full answer...
The Hickory Springs Manual Pull-Out Steps # 98224EXTALC1 were designed to either bolt or weld to a vehicle/RV frame. Assuming you have clearance and access to the bottom of your vehicle's frame this would easily install and fit well. view full answer...
Depends on what bike rack you have. If you have a Little Joe or SuperJoe you would want the # Y8890156, if you have a KingJoe you would want the # Y8890152. view full answer...
The reason your 2001 Dodge Caravan needs a taillight converter is because it has it's stop light circuit and blinker circuit on separate wires whereas standard trailer wiring has these two circuits combined. So this harness # 118376 combines the circuits like needed and also installs easily on your vehicle since it plugs inline with the factory vehicle wiring. view full answer...
I would recommend the Saris Bones part # SA805BL. This rack has been confirmed to fit your 2010 Dodge Caravan and is a great rack at a great price. It has all of the features of the more expensive racks yet doesn't cost as much. It's the best deal for sure.
Check out the review video I attached for more info.
If you plan on carrying any womens or alternative framed bikes without horizontal top tubes you may also be interested in purchasing a Swagman Easy-Out Women's and Alternative Frame... view full answer...
You will need to check your owners manual, or with the Chrysler dealer to determine the towing capacity of your 2005 Dodge Caravan. Once you know the capacity of the vehicle you will need to find a camper that weighs less than the vehicles maximum towing capacity, when fully loaded, to safely tow the trailer.
If you need a hitch for your Caravan, I would recommend the Draw-Tite Class III Trailer Hitch, item # 75119, if your vehicle does not have stow-n-go seating. If you do have stow-n-go... view full answer...
Nearly every vehicle with an automatic transmission has a transmission cooler. I would guarantee that your 2007 Dodge Caravan has one, especially since your local Dodge dealer told you the same.
Typically, the factory transmission coolers of vehicles are adequate at best when you are not towing so I would recommend you get a supplemental transmission cooler as well.
The best way would be for you to keep your factory cooler and then route a supplemental cooler, like the Derale Cooler #... view full answer...
I'd recommend going with a Class III hitch which uses the more popular 2 inch receiver opening for the best capacity and the widest selection of hitch mounted accessories. The Draw-Tite # 75119 Class III hitch fits all models of the 1998 Dodge Caravan, so that's what I'd recommend going with. I've confirmed that the hitch IS compatible with the Caravan Sport, unlike the Curt # C13315 you'd looked at.
For towing, you'll also need a trailer wiring harness like # 118334.
When we installed... view full answer...
The install of the front hitch part # 65062 that you referenced requires the use of a special high-quality 1/2 inch Rotabroach drill bit. view full answer...
Depending on the size of the bikes and how many you intend to carry, turn clearance may become an issue, especially if the tongue of the trailer is relatively short.
There is another method to tow and use a bike carrier that will provide some more clearance and reduce the chance of the trailer hitting your bikes. You could use Curt Multi-Purpose Ball Mount, part # D210. This will set the bike rack up another 4-3/4 inches, plus you can use a standard hitch mounted bike rack that you could... view full answer...
Yes, the Draw Tite hitch part # 36296 is a fit for your 2001 Dodge Caravan Sport. This hitch is a fit for all models of the 2001 Dodge Caravan.
For trailer wiring you then would want the part # 118376. I attached an install video for this as well.
For a ball mount you would want the part # 36071, with hitch balls # 19258 for a 2 inch ball or # 19256 for a 1-7/8 inch ball. view full answer...
The Curt hitch # 13389 is the correct fitting hitch for your 2007 Dodge Caravan with stow n go seating. The other two hitches fit different vehicle variations.
I attached an install video for this hitch on a 2007 Town and Country similar to yours. view full answer...
There are several coolers recommended for your 1990 Dodge Caravan. I have incldued a link to them for you. The type of coolant the vehicle uses is not a factor. Transmission coolers are not vehicle specific and are flow through devices with no moving parts so the type of fluid and the vehicle are not issues.
We recommend installing the largest cooler that will fit in the vehicle. This is because transmission fluid cannot be over cooled and because a larger cooler will be more efficient.... view full answer...
You'll be looking at adding a trailer hitch receiver and what's called a "Platform Style Rack" to your vehicle.
If you don't already have a hitch, you'll want to install one to start. I recommend going with the Draw-Tite Class III Max-Frame Hitch, part # 75119. This is a no drill, no trim install that can be completed by local dealers or certified body shops, or done as a home installation. I've included a link to an installation on a 2007 Dodge Caravan which is built on the same frame... view full answer...
The 2006 Dodge Caravan/Grand Caravan has a towing capacity dependent on the tow package and engine size. The 3.3L V6 can tow 2,000 lbs without or 3,600 lbs with the towing package. The 3.8L v6 can tow 2,000 lbs without or 3,800 lbs with the towing package. Your SXT model has a towing capacity of 3,700 lbs.
If you have stow-n-go seats, I recommend the Curt Class III # 13389 for your trailer hitch receiver. If you do not, then I recommend # C13362.
For your trailer wiring, I recommend... view full answer...
Go To Results