When we have asked Thule about how far the Thule Hullavator Pro Kayak Carrier and Lift Assist # TH898 hangs down from the top of the crossbars, they told us that it will extend down 40 inches, as you can see in the accompanying photo I added for you.
The one thing I do recommend with the Hullavator is to add the Thule One-Key System Lock Cylinders # TH450200 to lock it to your rack, helping protect your investment.
I have added a link to a video review for you to check out as well of... view full answer...
The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear # TLA8102 have a height of 16-1/2" from the top of the mounting bracket to the bottom of the steps when fully retracted. I've attached a photo of this to give you a visual. view full answer...
When the Roadmaster spare wheel and tire carrier part # rm-195225 is folded down it will sit 12-1/8 inches above the top of the hitch tube it installs into. You'd need to measure from the top of your hitch tube up to see if it would obstruct your rear door. See picture and attached review video for this for more info. view full answer...
That depends, your 2012 Winnebago's maximum gross trailer weight and maximum tongue weight are independent of those corresponding values of your hitch receiver. You are limited to the lower of the two values between your motorhome and the hitch receiver, so going with a hitch receiver with a higher maximum tongue weight does not guarantee you can carry anymore weight. You will have to contact the manufacturer to find out the frame capacity of your Winnebago. view full answer...
The Roadmaster 64" Single Hook, Straight Safety Cables # RM-645 is the overall length of the unit. If you are at all concerned with the amount of length I highly recommend going to a longer cable such as the 76" # RM-645-76 or the 80" Double Hook # RM-674. view full answer...
The capacity of scissor jacks is based on the individual jack. For example, the Scissor Stabilizer Jacks w/ Handle - 18-3/4" Lift - 10,000 lbs - Qty 4 # TJSCHD-24-4 each have a 2,500 lb capacity, but since these come in a quantity of four, the capacity is a total of 10,000 lbs.
Since your 2019 Micro Minnie 2100BH has a 7,000 lb GVWR, these scissor jacks would have more than enough capacity, and it is recommended you replace all of them at the same time.
If you were instead referring... view full answer...
The Adco 5th Wheel Skirt # 290-3502 is 266 x 64-inches. The answer you referred to also listed another model, part # 290-3501, which does indeed measure 236 x 64-inches. All three skirt sizes offered appear on the linked page. view full answer...
According to Yakima, the Yakima ShowDown Kayak or SUP Carrier and Lift Assist # Y04081 will hang down 26 inches from the top of the crossbars.
I do recommend adding the Yakima SKS Lock Cores # Y07202 to lock the ShowDown to your rack and help protect your investment.
I have added a link to a video review for you to check out as well of the Yakima ShowDown # Y04081. view full answer...
The fabric on the Solera 16' White Fade RV Awning Roller and Fabric (Std) # LCV000211492 is 16'. The roller and arms will stick out past the 16' of awning so you'd be looking at closer to 16.5'-17' total when you add those in. view full answer...
The distance/height from the ground to the mounting plate on the Ultra-Fab Rotating, Hitch Mounted Skid Wheels for RVs # UF48-979014 is 5-3/4". view full answer...
I have attached an image of the Draw-Tite Ultra Frame Trailer Hitch Receiver # 41947 referenced in your question with a few dimensions labeled.
The distance between mounting holes, from the left side mounting bracket to the right side mounting bracket is 30-1/2 inches. The distance between the mounting holes, center to center, is 3-1/2 inches for the closer of the two holes and 15-7/8 inches from the hole nearest the receiver to the rear bracket hole.
If you need any additional measurements,... view full answer...
I have listed the parts you have requested for your 2019 Winnebago Intent 26M below along with any installation videos we may have. The steering stabilizer and sway bars will fit both the 16,000 lbs and 18,000 lbs models and the SumoSprings are confirmed to fit your 26M.
Steer Stabilizer - Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets item # RM33RR
Front Sway Bar - Roadmaster Front Anti-Sway Bar item # RM-1139-148
Rear Sway Bar - Roadmaster Rear Anti-Sway Bar item #... view full answer...
The torque setting is 90 - 100 ft.-lbs for lug nuts on the wheel and tire combo you asked about, which is the following part number:
- Westlake ST235/75R15 Off-Road Tire w/ 15" Liger Aluminum Wheel - 6 on 5-1/2 - LR D - Black # LH46FR
For lug nuts I recommend the Kodiak Trailer Wheel Lug Nut - Stainless Steel # KALN1375S. view full answer...
While it is true that accessories with longer lengths apply more pressure to the trailer hitch receiver, unless you plan on using an extender like part # C45791 that simply places the location where the accessory installs further out than the hitch receiver, there isn't going enough of an extension for it to make a difference.
The Utra-Fab Dirt-Bike Carrier # UF48-979033 won't exert any extra force on the receiver so you can use the full 400 lb weight rating of the carrier if need be since... view full answer...
Per Swagman, the XP Folding 4 Bike Rack, part # S64960, has a weight capacity of 35lbs per bike with a total weight limit of 100lbs.This rack is compatible with 1 1/4" and 2" hitch receivers, it locks your bike/s to the rack, and it tilts forward while empty so you can access your trunk or hatch.
If you will be carrying women's bike/s with a step-thru frame you will also need a bike frame adaptor bar for each of them. The Swagman Deluxe Bike Frame Adapter Bar, part # 64005, will work... view full answer...