Derale Series 9000 Plate-Fin Transmission Cooler Kit w/ NPT Inlets - Class I -Extra Efficient

See what our Experts say about this Derale Transmission Coolers

• Complete Towing Setup Including a Transmission Cooler for a 2012 Ford Escape AWD 3.0
  I would be happy to help you set your 2012 Ford Escape up for towing. You're going to need a hitch, a couple of wiring harnesses, a brake controller and ball mount. Plus the requested transmission cooler. Since your Escape does not have the towing package you are going to need two separate wiring harnesses to have a connector like the Hopkins 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket item # HM40975. You will also need to hardwire in your brake controller since you do not...
  view full answer...
• Larger Transmission Cooler Recommendation to Replace Small One Where Fluid Still Gets Hot
  The transmission cooler part # D13611 that you referenced is a pretty small cooler. Since you are towing on steeper grades a larger cooler would be your best option. If you can fit the part # D13503 instead of what you currently have this would be a much better option. This cooler measures 11" Wide x 8-3/4" tall x 7/8" deep. Basically the larger the cooler the more efficient it will be at cooling the fluid. Since you already have the hard part done of installing a cooler all you would...
  view full answer...
• Transmission Fluid Needed for Transmission Cooler Installation
  When you install the Derale Series 9000 Plate-Fin Transmission Cooler # D13611 a little extra fluid will be needed. The last part of the installation instructions have you add fluid as needed and then drive the vehicle for a little while and recheck the fluid level. Not much additional fluid is needed unless much is spilled when you disconnect and reconnect the lines. Normally just a few ounces of fluid is needed.
  view full answer...
• Transmission Cooler Kit for a 2018 Ram 3500 Dually w/ the 6.7 Cummins Turbo Diesel Engine
  The best transmission cooler kit for your 2018 Ram 3500 Dually with the 6.7 Cummins Turbo Diesel engine is going to be the Derale Series 9000 Plate-Fin Transmission Cooler Kit w/ NPT Inlets item # D13611. This plate-and-fin heat exchanger provides increased surface area so that fluids can spread out along the finned chambers to cool faster. In addition to the increased surface area, this cooler also features turbulator technology, whereby fluids are agitated continuously. I have linked...
  view full answer...
  
• Transmission Cooler Recommendation for 2007 Toyota Highlander
  With transmission coolers "size does matter..." Basically the bigger the cooler you can fit in front of the radiator the better it's going to cool your fluid. Between the two you mentioned the part # D13503 would be the best option. It's size is 11" Wide x 8-3/4" tall x 7/8" deep. For your size vehicle this is the perfect size and would do a great job.
  view full answer...
• Transmission Cooler Recommendation for 2008 GMC Yukon
  A transmission cooler is exactly what you need to keep the transmission fluid at an ideal temperature which is below 200 degrees. Ideally, you'll want to get the largest cooler that will fit into the available space. The best spot to install a cooler is directly behind the front grille, in front of the radiator and the a/c condenser. The Derale # D13504 would be ideal if you have enough room to accommodate its 11 inch wide by 12 inch tall size. The cooler would tap into the return line...
  view full answer...
• Transmission Cooler for a 2015 Toyota 4Runner Towing a Pop-up Camper
  I have just what you need. The most popular transmission cooler for the 2015 Toyota 4Runner is Derale cooler # D13503. This cooler measures 11 inches wide, 8-3/4 inches tall, and 7/8 inches deep. It will increase the cooling capacity beyond what the factory system can handle alone to help keep your transmission fluid at a safe temperature when you are towing as well as when you are not towing.
  view full answer...
• Does Derale Series 9000 Plate-Fin Transmission Cooler Fit 2009 Ford Escape 3.0
  Yes, the Derale Series 9000 Plate-Fin Transmission Cooler Kit w/ NPT Inlets # D13612 does fit your 2009 Ford Escape and will work well. This has more cooling capacity than the # D13611 so it would be a better option!
  view full answer...
• What is Required for Towing a Trailer w/ a 2004 Honda Pilot
  I looked up an online version of your 2004 Honda Pilot's owner's manual and it states that additional transmission and power steering coolers are required to tow. It also states that a trailer that weighs 1,000 pounds or more should have its own operating brakes. I've attached an article on coolers that you might like. The firs thing in choosing one is find a place to put it in your Pilot. The best place is always in front of the radiator so it will get as much air flow as possible....
  view full answer...
• Transmission Cooler Recommendation for 2003 Honda Pilot
  If you're not planning on towing frequently at or near its 4500 lb capacity or in mountainous areas, the Derale # D13611 you'd looked at would be an excellent choice. The cooler is a plate fit design, which offers extremely high efficiency in a small package that won't take up much room on the front of your radiator. If you'll be pushing the vehicle harder by towing more frequently and planning on running up and down hills, a larger cooler like # D13502 would be a better choice. Unless...
  view full answer...
• Recommend A Transmission Cooler and Fittings For 1997 Mercury Grand Marquis
  The item you selected, the Derale Transmission Cooler, part # D13611 will work on your 1997 Mercury Grand Marquis as long as you have room to mount it on your vehicle. The ideal place to mount a transmission cooler for maximum cooling efficiency is behind the grill of your 1997 Mercury Grand Marquis but in front of the radiator. Part # D13611 is a plate and fin cooler and is very effective in cooling the transmission fluid. You will want to measure at the front of your vehicle to make...
  view full answer...
• Recommended Transmission Cooler For 1999 Honda Accord With 2.3L Engine
  The transmission cooler I recommend for your 1999 Honda Accord with the 2.3L engine is the Derale Transmission Cooler, part # D13503. This is a Class lll plate-fin cooler that will prolong the life of your transmission and help improve overall performance. This system comes with the hose, stainless steel clamps and radiator adapter. If space is limited on your Accord, you can take a look at one of the shorter coolers like part 3 D13611. I have attached some helpful articles that explains...
  view full answer...
• Recommended Transmission Cooler For 2006 Mitsubishi Raider
  For your 2006 Mitsubishi Raider, the Derale Series 9000 Plate-Fin Transmission Cooler Kit w/ NPT Inlets - Class I -Extra Efficient # D13611 is a small but strong transmission cooler. It requires no extra fittings for installation. For a better transmission cooler, I recommend the Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets - Class III - Efficient # D13503. This cooler is designed for Mitsubishi Raiders with late-model, electronic overdrive transmissions. This...
  view full answer...
• Larger Hose Fittings for Derale # D13611 on 2010 Mercury Mariner
  On the Derale Series 9000 Plate-Fin Transmission Cooler Kit w/ NPT Inlets - Class I -Extra Efficient # D13611, the fittings that come with the unit are 1/2" NPT x 3/8" hose barb. The other option for fittings are the Derale 1/2" NPT Male x 1/2" Barb Straight Hose Fitting - 2 Piece # D15712 along with the 1/2 inch inner diameter hose # D15700 and hose clamps # D13008. This slightly larger size is the only other option for the 1/2" NPT fitting on your cooler.
  view full answer...
• Recommended Transmission and Power Steering Coolers for 2019 Ford Explorer
  Yes, the general wisdom on supplementary fluid coolers for towing vehicles is that the transmission is top priority followed by the power steering system. The transmission cooler I recommend for your Explorer is the Derale Class III plate-fin cooler # D13503. This is because this cooler's 11 x 8-3/4-inch size allows it to very efficiently cool your transmission fluid a second time, after it is first cooled by the OEM cooler inside your radiator. The best install location is right in front...
  view full answer...
• Derale Transmission Cooler Recommendations For 2008 Chrysler Town and Country w/4.0L Engine
  The Derale Transmission Cooler you selected, part # D13611, would work on your 2008 Chrysler Town and Country as long as you have room to mount it. I would recommend the Derale Series 8000 Plate-Fin Transmission Cooler Kit, part # D13502, for your vehicle as it is much thinner. Part # D13502 measures 11 Inches wide, 7-1/4 Inches Tall, and 7/8 Inches Deep. You will want to measure on your vehicle to make sure you have room to mount the cooler. The most efficient and recommended spot to...
  view full answer...
• Transmission Cooler Recommendation and Installation on a 2011 Chevrolet Silverado 4.7L
  The plate-fin transmission coolers are more efficient than the tube-fin transmission coolers. Both types of coolers operate the same, but the plate-fin coolers uses smaller plates to allow more fluid to contact the aluminum surface inside the cooler. More surface contact results in greater heat dissipation. I have attached two FAQ articles on transmission coolers for you to check out. When choosing a transmission cooler, we always recommend installing the largest transmission cooler...
  view full answer...
• Transmission Cooler for 2016 Honda Pilot
  It is pretty common for aftermarket products such as transmission coolers to deliver performance that is superior to that of OEM components. Transmission coolers vary in their efficiency/cooling power and are given Class Ratings to indicate their effectiveness. Small is okay but bigger is definitely better when it comes to coolers. For example, a small cooler like the Derale # D13611 (about 11 x 4-inches) carries a Class I rating while the much larger # D13503 (11 x 8-3/4-inches) is rated...
  view full answer...
• Can the Average Do-It-Yourselfer Install a Transmission Cooler on a 2007 Chrysler Town and Country
  Installing a transmission cooler is not very difficult and I have every confidence that you will be able to install the Derale Transmission Cooler, # D13611, on your 2007 Chrysler Town and Country. Make sure you have the necessary tools. Your mechanical skills should serve you well for this installation. I can give you some installation tips. Transmission coolers are designed to be mounted flush against either the radiator or the AC condenser core. For maximum cooling ability, the heat...
  view full answer...
• Which Line Is Transmission Fluid Return Line on 2009 Chevrolet Tahoe
  Typically the return line of the transmission is the one at the bottom of the cooler. You can do a small test to determine which line is the return line. First, start engine while engine is cold. Put the transmission in drive for no more than 10 seconds Stop engine Feel the both of the lines, and whichever one is cooler is the return line that is taking the fluid back to the transmission. To install the cooler you selected, Derale Transmission Cooler, part # D13611, you will also need...
  view full answer...
• Transmission Cooler Compatible With The 5.3L V8 In My 2007 Chevrolet Tahoe
  We do carry a variety of Derale Transmission Coolers for your 2007 Chevy Tahoe. If you are looking for a class I Plate-Fin cooler, here it is # D13611. If you need a class II get the Derale Dyno-Cool Tube-Fin Cooler # D12906. There is a class III Plate-Fin available too, part # D13503 and also a class IV Tube-Fin # D12904. The difference between the Plate-Fin and Tube-Fin style is that the plate and fin models can cool better than the tube and fin models. Also, the higher the Class of...
  view full answer...
• What Is The Warranty Of Derale & Flex-a-lite Transmission Coolers?
  Derale transmission coolers, like the: -Derale Series 9000 Plate-Fin Transmission Cooler Kit w/ NPT Inlets # D13611, & Flex-a-lite transmission coolers like the: -Flex-a-lite Transmission Cooler # FLX400008 which is a confirmed fit for your 2008 Chevrolet Tahoe, have a 1-year limited warranty.
  view full answer...
• Installing a 7-Way Connector and a Brake Controller on a 2011 Ford Escape XLT
  Yes, the Universal Wiring Kit # ETBC7 and the Tekonsha Prodigy P3 # 90195 will also fit your 2011 Ford Escape. If you already have a 4-Way then you won't need anything else, however if you don't have a 4-Way then you will need part # 118251 if you have the factory tow package or part # 118551 if you don't have the factory tow package. Attached is a sample installation video of the ETBC7 kit being installed on a 2011 Escape for you to reference. The brake controller being installed is the...
  view full answer...
• Secondary Transmission Cooler For A 2000 Honda Accord V6 Needed
  The best way to select the correct transmission cooler is by determining where there is enough space to mount it. The attached diagram shows the best three positions to mount the transmission cooler in order. Transmission coolers are more efficient when they receive maximum air flow. The "A" transmission cooler location in the diagram is 100% efficient so a larger transmission cooler is not needed to compensate for the loss of cooling power. My recommendation is the Derale Dyno-Cool...
  view full answer...
  

Do you have a question about this Transmission Cooler?