Replace your old and worn out weather stripping around doors and hatches of your RV before water damage creates a costly headache. Adhesive backing is pre-applied for an easy DIY install.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everybody, Andy here with etrailer.com, and today we're gonna take a brief look at this rubber sponge cushion strip for your RV or trailer doors. With this rubber seal, you are going to be able to replace your old and worn out weather stripping around your doors and hatches of your RV before water damage creates a costly headache. As you can see here, this is a peel-and-stick installation with the pre-applied 3M adhesive backing. You simply remove the backing and apply the seal to your frame. Surface preparation is recommended to remove any old adhesive and all you need is pair of scissors to trim the extra seal that you do not need. This is made in the USA of EPDM dense rubber that won't shrink, crack, or fade over time, so it's very durable and it's going to be resistant to UV damage as well.
This is going to be a 15-foot-long strip that you are going to get. And just some additional measurements, looking at the overall width, we are sitting right at about 3/4 of an inch wide. And then looking at the height, we are sitting right at about 5/16 of an inch tall. Well, that's gonna conclude our brief look today, I do hope that it was helpful for you. Again, my name is Andy.
Thank you for joining me..
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.