Summer Starts Here - Save up to 70%
Replaces 1 single-acting angle cylinder on your Fisher snow plow. Angle cylinder helps angle your blade so you can easily clear the roads. Rod extends up to 31-1/4" so you can push snow easily off to the side.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're going to take a look at the replacement 1 1/2 inch by 12 inch power angling cylinder for the Fisher snow plows. Now this part'll replace the power angling cylinder on your Fisher snow plow; it does replace the Fisher part number 20117K and part number A3660.It does use a 1 1/2 inch diameter rod. So the rod right there, if we put a ruler on that, there's your 1 1/2 inch diameter. It's 12 inches long. So it has a 12 inch stroke with a single acting power angling cylinder. The base right down here has a diameter of 1 and 3/4 inches.
And the pin size, which are these two holes here that the pins will go in, the opening of that diameter is 1 inch.Now the center-center dimension from this pin hole to this pin hole, when it's retracted, like it is now, is 19 and 1/4 inches. And when this rod is extended out, would be 31 and 1/4 inches. The port type right down here is a 1/4 inch NPT size. The location of it is 90 degrees, and this part is made in the USA.That should do it for the review on the replacement 1 1/2 inch by 12 inch power angling cylinder for the Fisher snow plows.
Average Customer Rating: 4.8 out of 5 stars (6 Customer Reviews)
Replaces 1 single-acting angle cylinder on your Fisher snow plow. Angle cylinder helps angle your blade so you can easily clear the roads. Rod extends up to 31-1/4" so you can push snow easily off to the side.
Everything ordered came as promised on time
I boiught two pistons. On the piston end of one of them the 1" pin wouldn't go through so had to ream it out with a 1" drill bit. Not a deal breaker but something I shouldn't have needed to do. If you check some of the older fisher pistons they use an O ring JIC right angle fitting and the original fisher hoses have a much tighter 90 degreee swivel elbow. I had to orient the pistons so the hole into the piston faces outward as there was not enough room to get the new hoses I have (1/4" IP thread) installed between the side of the piston and the plow frame. My hoses came with a wider 90 degree elbow.
Quick delivery, perfect condition, fits and works.
I ordered two angle pistons for my plow and they fit perfectly. The best price I found as well. Thank you!
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.