To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
These premium mud flaps are easy to install and digitally designed to fit your car or truck. Protect your Chevrolet Silverado and your trailer from road debris. Flaps are constructed of durable thermoplastic resin.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today on our 2013 Chevy Silverado, we'll be installing the Weather Tech Front Mud Flaps part number WT110010. Now to begin our install, we'll first going to go ahead and take the tire and turn it out to give us more room to install the mud flap. You can see that we can get to all four fasteners that we'll need to work with. Next just using some water and cleaner we'll go ahead and remove the dirt, dust and debris that is build up here. By removing the dirt, dust and debris, it will help prevent any scratching of the paint when it gets trapped between the mud flap. All right, next we'll go ahead and remove the 2 bottom push pin fasteners. To remove the fasteners, we'll pry out on the center of the fastener using a flat blade screwdriver, work that center fastener out.
Over time they can become a little difficult, a little stubborn because they are going to build up with dirt being part of the inner wheel alignment but as we get it out, we can go ahead and remove the center section and then the inner section. I'll repeat the same process with the 2nd push pin fastener here and we'll set those aside. Make sure we hang on to one of them as it will be reused to install the new mud flap. Next we'll need to remove the 2 X headed screws and now with the manufacturers fasteners out of the way, we are going to put our mud flap into position. I'm a start with the manufacturers X headed screws and reinstall it. We'll go through the mud flap, do the wheel liner and back into the steel connection point.
We'll do that for both fasteners. Now I'm just going to install it loosely this time. Next we'll move to the first push pin fastener that we removed earlier, take the inner portion of the fastener, go through the mud flap, back into the wheel well and wheel well liner. Now once that is in place, we'll take the inner portion of the fastener and press it into position and it will be a little firmer than when it came out. Once we get that into snap in place for the 4th attachment point, we are going to use the provided bolt and nut. The bolt will go through the mud flap, through the wheel well liner, through the fender and get secured on the inside with the flange nut.
Now we are ready to go ahead and tighten them down. I'm going to start with the X headed screws first. Now with the driver side installed, we'll go ahead and turn the wheel out for the passenger side and repeat the same process. Now that will do for the install and setup of our Weather Tech Front Mud Flaps part number WT110010 on our 2013 Chevy Silverado. .
Average Customer Rating: 4.8 out of 5 stars (1389 Customer Reviews)
These premium mud flaps are easy to install and digitally designed to fit your car or truck. Protect your vehicle and your trailer from road debris. Flaps are constructed of durable thermoplastic resin.Got what I needed and very helpful! Boat trailer parts and truck parts thank you for on time shipping! Will order more parts from you!
Perfect fit, good instructions. Took about 15 min. to install.
I am very disappointed with the Weather Tech mudflaps, not because it took forever for them to be delivered (though it did -I was not told by e-trailer that they weren't in stock the day I ordered them), but by the fact when they were finally delivered, they were missing instructions (front mudflaps) and parts (rear mudflap was missing the center screw to the lock; the lock was found loose in the bag. I had to go to home depot to try and find the errant screw - i was not about to send them back and wait some more).
I have a lot of weather tech products on all 4 of our cars as well as full front and rear mats in the truck, and have never had a problem like this before. Both irritating, disappointing and requiring an additional cost of money and time to rectify).
The etrailer packing was excellent, and once i collected all the necessary parts / instructions and figured out how to re-assemble the loose lock, the installation proceeded in an orderly manner though taking longer than anticipated based upon the etrailer video. The quality of the actual flaps looks to be excellent and they look good on the truck. If there had been some visible quality control initially upon opening the packages, I would have given them 5 stars. Unfortunately that is not how it played out.
Super easy to install and it took about half an hour. Look good after a year and are still solid. Id buy them again.
Did not fit well on the 2022 Dodge Ram 3500. The rear flaps did not quite fit the OEM fender flares on the vehicle. Too tight - not enough clearance to sit nicely against the flares. There was also no hole for the trim fastener so had to drill a 1/4" hole for little plastic fastener - not a big deal. Hoping the front ones fit better, but they were worse. Same story - the "digital fit" flaps did not fit the OEM fender flares. Tried a heat gun to hopefully warm the flap and maybe get them to fit together better, but couldn't quite get it. I'll need to get some longer fasteners, otherwise one bolt and the little plastic tab are all thats holding it on. Maybe if the weather warms a bit...? Def not as advertised.
Just like the description says...easy install, no drill, digital fit. Looks like they came with the truck. Highly recommend.
Mud flaps were easy to install and fit great on my 2023 Tundra Hybrid Max
Look great! Look OEM. Wish all the hardware was black. And in the front the two screws you pull out both sides, trash go get something a little longer and more girth. etrailer was great the arrived earlier then expected.
Well designed and fit just right. Look great and seem to be made from durable material. Installation was straight forward and easy.
Fantastic product. Very easy installation. High quality. Very fast delivery! Etrailer is the best as always!
holes did not line up with pre existing holes on car
for installation. Very hard
to install. will NOT buy weathertec again
These mud flaps are great! Good Instructions and install went quickly. They look really good and should perform well, protecting the rocker panels and the side steps from mud and stones. Very pricey but good quality. Front Pair.
This is a good investment. First, etrailer is a great place to get what you need for supplies! The weathertech mud flaps are a great addition to a raised F-250 with larger tires that pulls. This will provide the rest of the protection I need as well as cut down on debris that the tires throw up at other cars/trucks. Very easy to install and if I want to remove them then I have all the pieces necessary except for the push grommets which I can get anywhere. I think I will leave them on for a while....not bad looking either.
I was apprehensive about buying these as the weather tech company said they would not fit. My vehicle has power running boards and 22” wheels..I researched forums and took a chance. They fit…no problem. See attached photos and video.
Thanks
For someone who is "old school" and reluctant to install plastic onto a machine, I'm impressed with the ease of installation and durability so far. I've put about 7500 miles on them without an issue. And thanks to Etrailer for carrying great products and providing great info to consumers. You folks have a great Business model!
Delivered timely and installed easily. Great product.
Took a little effort to get it to match up with the plastic wheel well fender flares but once I did I have not had any issues. Looks somewhat subtle but is pretty effective at stopping thrown debris onto the paint.
Great service item was shipped and received quickly. Mud flaps were easy to install.
I ordered Weather Tech mud flaps for my GMC Sierra 1500. The front flaps were easy to install by using existing fasteners installed on the truck by GMC. The rear flaps were slightly more challenging requiring the placement of clamps (integral to the flaps) on the rear fender. The entire installation of all flaps required about 45 minutes. they look great and they will protect my fenders from being damaged by road debris.
Great product, easy to install, I didn't find the instructions, but was easy to figure out. I would recommend this product
Seems like a solid product. Made in the USA. The instructions were a bit off. So I jumped on the etrailer YouTube account, found the install video. Issue solved. I will say I'm more impressed with etrailer than weathertech. However, nice fit and finish. I would recommend this product.
I ordered a set of weathertech no drill mud flaps for my new 2022 Colorado and they fit great and easy to install. Well after a couple of weeks I put on GM flares so I had to order another set for flares. Same thing excellent fit and easy install. Quick shipping and good service.
East install on 2023 Thor Compass 23te Motorhome. Fit perfectly. Place some tape on a open end wrench to hole the nut on and you are good to go.
Good quality. Arrived quickly
Easy to install.
Fit my 2020 Honda Ridgeline perfect! Easy to install with easy to follow instructions. Match oem black plastic great. Really complete the look of truck. Very happy customer.
Do you have a question about this Mud Flap?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.