To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Quickly and easily install a 4-way trailer connector on your vehicle with this custom wiring harness. T-One connector plugs directly into existing wiring. Powered ModuLite reduces strain on wiring system.
Features:
Specs:
Installation
This custom-fit T-One connector plugs into your vehicle's wiring harness, which is located inside your trunk, behind the tail lights on both the driver's side and passenger's side. You will need to remove the rear threshold panel and some of the felt lining to access the harness.
Once you've plugged in the T-connector, run the hot lead with the attached fuse holder to the car battery, which is also in your vehicle's trunk. Connect the fuse holder to the positive terminal on your battery and insert the provided fuse.
Once installation is complete, the 4-way flat connector will be stowed in your trunk.
It is recommended that you use a small amount of grease on all electrical connections - the plugs on your automobile and the 4-pole connector itself - to help prevent corrosion.
A ModuLite power module is built into this T-One connector. With a ModuLite, your trailer's lights will be powered without overloading your vehicle's electrical system. Because the module draws power directly from your car's battery and bypasses the electrical routes that are used by a basic wiring harness, there is virtually no draw on your tail light circuits.
California residents: click here
Average Customer Rating: 4.8 out of 5 stars (12 Customer Reviews)
Quickly and easily install a 4-way trailer connector on your vehicle with this custom wiring harness. T-One connector plugs directly into existing wiring. Powered ModuLite reduces strain on wiring system.Easy installation on 2015 Chrysler 300.
I have a 2016, 300c awd. The Tekonsha trailer wiring harness was easy to install and use. I wasn't to wild about how they colored the power and ground wire. The ground wire is white and the power wire is black (closer to house AC wiring). I would prefer it to be black and red (like automotive wiring). The power wire also asks you to splice an additional black wire on the end of it than a yellow wire on the end of that. Seems like useless extra steps and splicing. Overall, the product made the job simple and easy and I didn't have to cut any factory wires. I would buy it again if needed.
The single passenger side wire is too short to allow much room to find the best place to locate the control module. Other than that, installation was easy and it works well.
great service ANd great product.
Excellent product with excellent design and instructions for installation!
Easy install. Written instructions tell to drill a hole in trunk pan for chassis ground, instead just stack the ring terminal with the main chassis ground on the stud near the battery. Works well overall
Easy to install, customer for life
Do you have a question about this Custom Fit Vehicle Wiring?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.