T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

See what our Experts say about this Tekonsha Custom Fit Vehicle Wiring

• Recommended 7-Way and 4-Pole Trailer Wiring Harness for 2018 Honda Pilot
  The easiest way to have both a 4-pole and a 7-way trailer connector for your 2018 Honda Pilot would be to begin by installing a 7-way trailer connector, part # 118286 and then use an adapter like # PK12716 when you want to tow a trailer with a 4-pole connector. I've linked to videos for both these products. There's an alternative if you'd rather not mess with an adapter. You can use a T-harness like part # 118384 which would plug inline between the 7-way and the harness provided by the...
  view full answer...
• Will Plugging in a Rampage LED Light Bar Disable Backup Sensors on a 2009 Chevy Suburban
  It is likely that if you were to plug in the 4-Way, # 118384, and then plugged in the Rampage light, # RA960134, it would still shut off the back up sensors. This is because you are teeing into the factory harness so there would still be power draw through the factory wiring. To prevent that from happening you would need to hardwire in a 4-Way to the tail light wiring on your Suburban using # C59236. Since it pulls power from the vehicle battery and signals from the tail light wiring it...
  view full answer...
• 4-Pole Trailer Wiring Harness for 2014 Volkswagen Tiguan
  The TowReady T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118384 that you referenced is not a fit for the 2014 Volkswagen Tiguan. This 4-pole harness uses a standardized round U.S. Car Connector to plug in to the vehicle wiring and your Tiguan does not use this type of connector. Currently there is one confirmed fit for a 4-pole trailer wiring harness for your vehicle and it is a hard-wired type converter, part # 118675 from Tekonsha. This kit installs at the tail...
  view full answer...
• Malfunctioning Right Turn and Brake Lights with Factory Installed 4-Way Trailer Connector
  Since you have a factory 4-Way and 7-Way, they will be wired to the same harness on the vehicle. The extra 3 wires for the 7-Way go directly to the plug but the 4 shared light wires should be split. We need to determine if the problem is between the 4-Way and the harness connector or if it is further up the harness in the vehicle wiring. Open the cap for the larger round 7-Way at the rear of the vehicle. As you look into it, the blade pin in the 3:00 position would be for right turn and...
  view full answer...
• How to Add Second 4-Way Connector to 2016 Ram 1500 for Light Bar
  The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118384 is exactly what you're looking for as it tees in with the US CAR connection at the back of the factory wiring on your 2016 Ram 1500 and provides you with an additional 4-Way connection for your light strip. This doesn't pull the reverse signal so you will need to tap into that function.
  view full answer...
• 4-Way Recommendation for a 2012 Nissan Titan with 7-Way
  The T-One Vehicle Wiring Harness # 118384 that you referenced would be the correct product for your 2012 Nissan Titan with a 7-way to also install a 4-way. It will plug inline with the 7-way harness you have on your vehicle.
  view full answer...
• Part Needed to Add Second 4-Way to Rear of 2016 Ford F-150
  What you could use is the part # 118384. This 4-way will plug in line with the 7-way you have at the rear of your 2016 Ford F-150 and it will provide you with an additional 4-way at the rear of your truck.
  view full answer...
• Recommended Wiring Harness For 2020 Dodge Durango Without Factory Tow Package
  There is a 4-pole wiring harness available for the 2020 Dodge Durango without factory tow package but the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # 118384 is for vehicle's with the tow package. I recommend to use the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # 118617 which plugs in behind the vehicle's taillights. This will give you a 4-pole flat at the rear of the Durango. I have attached a video for your reference. The hitch I...
  view full answer...
• Boat Trailer Pulled by 2001 Chevy 1500 Has Lights That Will Not Work When Brakes are Applied
  I would suspect a poor ground connection on the trailer. Most trailers use a ground connection at the front of the trailer, with each lamp picking up its ground connection by its physical contact with the trailer frame, in effect, using the trailer itself as part of the ground circuit. Take a look at the grounding point for the trailer connector, it can usually be found on the trailer tongue near the coupler. Make sure that this ground connection is tight, and connected to clean metal....
  view full answer...
• Will Tow Ready 4-Pole Trailer Adapter # 118384 Work On 2010 Ford F-150 Lariat
  For your 2010 Ford F-150 Lariat, the Tow Ready 4-Pole Trailer Adapter # 118384 will work fine to connect your trucks power supply to your LED strip brake light. I have included a link to the installation instructions for this item. To prevent corrosion on your adapter, you might be interested in Plews & Edelmann Dielectric Grease # 11755. It helps prevent electrical failures caused by corrosion and moisture and I have provided a link to a video demonstrating how it can be used.
  view full answer...
• Will TowReady 4-Pole Trailer Adapter for Trucks w/ Factory 7 Way, Part # 118384, Work on 2010 F-150
  The TowReady 4-Pole Trailer Adapter for Trucks w/ Factory 7 Way, Part # 118384, is an adapter that is designed to provide a 4-pole trailer connector on vehicles that have a factory 7-way. This Y-shape harness plugs into the existing 7-way and provides both a 7-way connector and a 4-way. This enables you to add the 4-way connector without losing the 7-way, giving your F-150 the ability to tow trailers with either type of connector. If your 2010 F-150 has the factory tow package (but no...
  view full answer...
  
• Availability of Adapter to Convert 7-way Trailer Connector on 2009 Chevy Silverado to a 4-Pole
  We have several different options that would allow you to plug in a trailer that uses a 4 pole trailer connector. If you wanted to leave your current 7-way trailer connector in place, you could simply use a plug in adapter like part # PK12716. We don't offer a plug in adapter that would provide both a 7-way and a 4-pole and retain your existing 7-way, but if you'd be willing to remove your current 7-way, part # HM40975 would provide both a 4-pole and a 7-way and would not require an adapter....
  view full answer...
• Troubleshooting Trailer Running Lights Not Working with Ram Truck
  If the trailer running lights aren't working when hooked up to your Ram and all the related fuses are good then I recommend testing the connector at the rear bumper to narrow down the area of concern. Use a circuit tester like # PTW2979 and test the running lights pin on the connector while you have that function activated on the truck. If you are getting power then you know the problem is somewhere on the trailer. If you don't get power then it's somewhere on the truck. If you didn't...
  view full answer...
• Will the Curt Trailer Hitch Receiver # 13301 Work on 2011 GMC Sierra 1500
  Yes, I checked with Curt and this Curt Trailer Hitch Receiver, part # 13301, is a confirmed fit for your 2011 GMC Sierra 1500. I attached installation instructions for you to check out. You may be interested in the following products to complete your towing setup: Ball Mount 2-3/4 inch Rise or 4 inch Drop # 2753 Hitch Ball with 2 inch Diameter and Medium Shank # 19247 Tow Ready Custom Fit Vehicle Wiring # 118384 (instructions attached)
  view full answer...
• Recommendations for a Complete Setup for Towing a Travel Trailer with a 2010 Lexus GX460
  I can help you get set up with all the right equipment for towing a travel trailer with your 2010 Lexus GX460. Let's start with what you will need for the vehicle itself. The hitch I recommend for your 2010 Lexus is the 2 Inch Draw-Tite # 75685, this custom fit hitch has a tongue weight capacity of 500lbs and a towing capacity of 5,000lbs. which will work great for your trailer. Next for the vehicle you will need wiring to power the taillights on the trailer. Your Lexus should already...
  view full answer...
  
• Can a 4-Way Flat Trailer Wiring Connector be Added to a 2010 Chevy Silverado
  A 7-way will have a round socket and blade-style pins in it. The 2010 Silverado would either have a 7-Way connector or no connector. If the connector is present, use a circuit tester like # PTW2993 to test the function on the pins while someone sits in the truck to turn them off and on while you test. If there is no connector, you would need to install # PK11916. All of the wiring will already be present, you would just need to plug this connector in. If you wanted to change it over to...
  view full answer...
• 7 to 4-Way Adapter for 2010 Buick Enclave w/ Factory Tow Package
  If your Enclave has the 7-Way connector that has the factory harness that plugs into the rear of it, the 4-Pole Trailer Adapter for GM trucks with Factory 7 Way, part # 118384 will work great for you. Another option would be to use an adapter that would plug into the front of the 7-way, like the 7 to 4-Way Adapter with Tester, part # 47345.
  view full answer...
• Difference Between Tow Ready Trailer Wiring Harnesses For a 2012 Jeep Liberty
  The difference between the Tow Ready trailer wiring harnesses, # 118554 and # 118384, is how they connect to the vehicle. If your 2012 Jeep Liberty came with a factory tow package, then you would just need part # 118384. There should be a factory tow package wiring harness behind the rear bumper of your Jeep that is capped off. You will simply remove the cap, plug in this harness and you are good to go. If your Jeep Liberty did not come with a factory tow package, but the factory plug...
  view full answer...
• Trailer Running Lights Not Working when Using a 7-Way to 4-Way Adapter
  I assume you meant 7-Way since there are no 8-pin connectors. The 7-Way to 4-Way adapters will have the pins in the standard locations for the trailer lights but no other pins will be present. Rather than changing the pin out on the adapter it would be easier to swap wires around on the vehicle side 7-Way connector to the positions you need. The 7-Way trailer connector can be opened up and the wires switched around. If your 7-Way cannot be opened then you will have to cut and splice the...
  view full answer...
• Installation of Tekonsha P-3 on 2005 GMC Envoy Denali
  Does your Envoy Denali have the tow package with the 7-way trailer connector on the rear of the vehicle? If so, you would just use the loose tow package wires that are already located under the dash. The circuits involved are already circuit protected, no additional circuit breaker is required. We have an installation video showing how to locate the tow package wiring and how the wires would match up with your brake controller. I will provide a link to the video below. If your Envoy does...
  view full answer...
• Troubleshooting Trailer Brakes that Don't Work with Only One Vehicle and Trailer
  This is mostly likely a bit of corrosion that is on the pins of the trailer wiring connectors. I would take sandpaper to all of the pins on the problem trailer and truck to see if getting them clean allows the full connection to be made. It also could be a partially bent pin so check for that as well. Other thing to check would be the ground circuits of the trailer wiring. Just go over them and make sure nothing is disconnected or damaged.
  view full answer...
• Troubleshooting Trailer Lights When Trailer is Connected to 2004 GMC Sierra 1500 4X4
  It sounds like a problem with the ground or wiring on the trailer, but it would be wise to check all of the components in your wiring system. You can test the trailer connectors on the 2004 GMC Sierra and the trailer with a circuit tester like the Quickee Tester, part # PTW2993. I am including a link to a FAQ page on trailer wiring that will show you the functions of each pin on your connector, depending on if it is either a 4-Way, 5-Way, 6-Way, or 7-Way. This will help you determine if...
  view full answer...
• 4-Way to 7-Way Wiring Adapter
  The 4-Pole Trailer Adapter for GM trucks with Factory 7 Way, part # 118384 would give you a 4-way plug, but to get the 7-way plug as well you will need a 4-way to 7-way and 4-way adapter, part # 37185.
  view full answer...
• Troubleshooting Factory Brake Controller of 2015 Dodge Ram 1500 Not Showing Voltage on 7-Way
  Your problem could be as simple to fix as cleaning the pins on the 7-way of the trailer and truck. It's very common that corrosion or dirt prevents the brake controller output circuit from making a solid connection and preventing the controller from being able to work. Also, volt meters typically don't put enough of a draw on a brake controller circuit for it to register as a trailer being connected and allow it to work properly. Try cleaning the pin of the connector and then inspecting...
  view full answer...

Do you have a question about this Custom Fit Vehicle Wiring?