Replacement Remote Control Socket Assembly for Superwinch Winches

Video Transcript for Review of Superwinch Replacement Remote Control Socket - SW94FR

Hi, there, I'm Michael with etrailer.com Today, we're gonna take a quick look at this Superwinch replacement remote control socket. This is going to replace the original remote control socket for your Superwinch winch. This will work with several different Superwinch models including the Tiger Shark, the 9,500 pound winches and the 11,500 pound winches, as well as the LP8500 and the LP10000, as well as the UT3000 winch. This is a direct replacement from Superwinch so you can trust. It's gonna integrate well. You do not have to worry about compatibility issues or anything like that.

So your remote control will just slide onto that opening there. You've got those three prongs are ready to receive that. As far as getting this installed, they do have the white and black wires have that spade female receiver are there. So it should be just as simple as pulling it off of the original, putting those prongs in there. And then our red wire is gonna have this ring terminal so we can easily get that mounted in place as well.

They do have a replacement hardware here for you so you can get the plug mounted on your winch just like the original was. And, of course, the cap is included as well. So when you're not using the remote, you cover that up and protect your connection points from any moisture and dirt and that sort of thing. So it should be very easy to get this replaced. Basically, just removing the old one and putting this one in its spot should do a really good job of allowing you that solid connection point again, for your remote.

So if the original has become damaged or whatever the case may be, this is gonna be a great option to get you up and operational again. So that's gonna complete our look for today. Again, I'm Michael with etrailer.com, thanks for watching..