Caliper-mounting bracket is designed for use with 13" rotors that have an 8 on 6-1/2 bolt pattern and either 9/16" or 5/8" wheel bolts. Mounts on 4-bolt, 8,000-lb Dexter brake flange. E-coat finish provides corrosion resistance.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today, we're going to take a look at the replacement E-coat mounting bracket for the Kodiak disc brake caliper on 8,000 pound Dexter axles. This caliper mounting bracket will mount to the brake mounting flange on your trailer axle, and it holds the disc brake caliper. It's made of a heavy-duty ductile iron construction. This one has a nice E-coat finish on it to provide corrosion resistance for fresh water and limited salt water use. They do emboss the bolt holes up here to provide extra thread contact for your caliper guide bolts. It gives you a nice tight, secure connection between the brake and the caliper.
It does offer side support to ensure that the load is carried by the bracket, not just the bolt, and the stiffeners will help reduce vibration when you brake. This is a universal design, so it is designed to work with either left hand or right hand four-bolt brake flanges.This part is made in the USA. Again, the application is for calipers on disc brakes with over-the-hub rotors. The axle it goes on is 8,000 pound Dexter axles. The brake rotor diameter that'll fit is 13 inch diameter.
The brake flange configuration is a four bolt.And just to give you a few measurements on that, the four bolt, we're going to first measure the horizontal center to center bolt pattern. You're looking right at 3-3/8 inches. And then vertical center to center is right at 3-5/8 inches. Then the diameter of this round, that's where it goes over the axle, is going to be right at 3-7/8 inches.That should do it for the review on the replacement E-coat mounting bracket for Kodiak disc brake caliper on 8,000 pound dexter axles.
Average Customer Rating: 5.0 out of 5 stars (1 Customer Reviews)
Caliper-mounting bracket is designed for use with 13" rotors that have an 8 on 6-1/2 bolt pattern and either 9/16" or 5/8" wheel bolts. Mounts on 4-bolt, 8,000-lb Dexter brake flange. E-coat finish provides corrosion resistance.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.