Replacement 1/4" Elbow for Air Lift Ride Control Air Helper Springs - Qty 1
(34 reviews)
Price: $10.14
In Stock
Replacement 1/4" Elbow for Air Lift Ride Control Air Helper Springs - Qty 1
Item # AL21837
Our Price: $10.14
Will this fit?
To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
In Stock
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Need help with installation?
Locate installers near me- All Info
- Reviews (34)
- Q & A (0)
- Videos (1)
- Photos
Air Lift Accessories and Parts - AL21837
- Air Suspension Compressor Kit
- Vehicle Suspension
- Connectors
- Elbow Connector
- Air Lift
- 1/4 NPT
Replaces (1) 1/4" elbow for your Air Lift Ride Control air helper springs (AL59544 or AL59568).
Features:
- Replaces a 1/4" elbow for your Air Lift Ride Control air helper springs (AL59544 or AL59568)
- Quantity: 1 replacement elbow
21837 Replacement 1/4" Elbow for AirLift RideControl Air Helper Springs - Qty 1
California residents: click here
Video of Replacement 1/4" Elbow for Air Lift Ride Control Air Helper Springs - Qty 1
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Video Transcript for Review of Air Lift - Vehicle Suspension,Air Suspension Compressor Kit - AL21837
Today we're going to take a quick look at the replacement 1/4 inch elbow for airlift ride control air helper springs. This is going to be an important component in our air bag system, this is actually where we push in our 1/4 inch air line. So this is a push to fit connector.Once you push that air line in, you'll feel it go in once and then push a little bit further and it will stop at that second point. That's when we know we have it locked in place. To release it you would just push in this little collar and then release the line there. So if you need to replace one that's just leaking out a little bit that's how you do it there.
And then we'll have our little threads that are covered with some thread sealant on the one side. You want to make sure that you get this tightened down enough to where that thread sealant is fully engaged. Or it's fully in the threads of the bags.This is a direct replacement from air lift, so you know it's going to work with your air lift ride control air helper springs. It does have that 90 degree turn, so we can get it installed properly. But then it does also swivel independent of that little nut collar there.
So we can get it turned to the right angle that we need it to be. So we can connect in our line, and have it going in a nice even swoop. You don't want to have any really sharp edges in your air line, so it doesn't get kinked up.As far as dimensions, just really quickly it's about an inch wide from the outside edge to the front of that connector. And about an inch tall. It does fit that 1/4 inch air line tubing.
And it does come as just a single quantity.And that's going to do it for our look at the replacement 1/4 inch elbow for air lift ride control air helper springs.
Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Customer Reviews
Replacement 1/4" Elbow for Air Lift Ride Control Air Helper Springs - Qty 1 - AL21837
Average Customer Rating: 4.8 out of 5 stars (34 Customer Reviews)
Replaces (1) 1/4" elbow for your Air Lift Ride Control air helper springs (AL59544 or AL59568).by: Randy 03/28/2024
Etrailer is always very helpful and easy to get a hold of.
by: Joe03/02/2024
Perfect fit for the broken elbow in my air spring.
by: George 03/28/2024
Good product. Thanks
by: Don 06/02/2023
I bought these to replace the straight fittings that came with the air bags that I had installed. They work fine, the only issue I had was I had to get a bushing for the fittings to install on the Pac Brake bags. Just a difference in the bag design.
by: Bradley 03/11/2023
Much better upgrade to my previously plastic elbows. Expecting this one to outlast the 15 year old airbags by a lifetime
by: Michael08/27/2022
Two of these elbows came as part of the air bag kit that I ordered. Unfortunately, one of them was damaged and would not hold a good seal on the air hose. I contacted etrailer, and they immediately sent out a replacement at no charge. It worked perfectly. Excellent customer service.
by: Jimmy 11/01/2022
Exactly what I needed to repair my air line for air bag suspension!
by: Daniel 07/07/2020
First of all Tanith and William's customer service was awesome! I needed the Airlift items and parts and they had them to my house basically the next day. I pulled my 39 foot Keystone Cougar to Yellowstone and back and the airbags made a huge difference. Before I left town the elbow fitting snapped during the final steps of my install and I needed the part. Tanith got it to me the next day. These folks rock!!!
by: Don R.06/15/2023
Exactly what I was looking for
by: Cory03/15/2022
Perfect. No issues with leaks or breaking them.
by: Rick 12/11/2021
This will be the second time I had to replace these elbows because of breakage. I am sure it was not the installation, had it checked twice and everything was good according to the pros. Keeping my fingers crossed.
by: AC9608/04/2022
Item arrived in a timely manner, and as prescribed. Will order from etrailer agsin.
by: Randall 02/06/2023
Excellent product just not what I neede d.
by: Jay 02/01/2023
Perfect match
by: Robert11/02/2022
It took from oct5 to oct28 and lots of phone conversations finally paul got it straitend out thank you paul
by: William 12/18/2022
Awesome transaction
by: Rodney11/30/2021
The part works. But still had a small leak someplace in system. Would lose 30 psi in a couple weeks time.
by: Frank03/20/2022
Old ones would not hold the hose but the new ones fixed the problem.
by: William08/21/2022
all good,already installed!!
by: Igsnatz12/30/2020
Perfect
by: Mike06/20/2019
Good
by: Bob04/10/2022
Very fast shipping
by: William 04/08/2024
by: JOHN12/09/2020
by: Brian 09/07/2023
25
34
Show More Reviews
See what our Experts say about this Air Lift Accessories and Parts
- Air Bag Inlet Valve Installation Location for Firestone Air Helper Springs on 2021 Nissan PathfinderYes, this is the only way to install the Firestone Air Helper Springs item # F4118. The top of the air helper spring makes contact with the factory bump stop so there is no way to install an air valve. The air bag only limits how much your coil spring compresses when under a heavy load, in the event of an air bag failure your coil spring would still function as normal. I have linked a review video that will demonstrate the function of the air helper springs and the install method. I recommend...
view full answer... - How to Fix a Leak on a Elbow Valve on an Air Lift Air BagTo remove the valve on the Air Lift LoadLifter 5000 Ultimate Air Helper Springs item # AL88338 you will need to remove the air spring from your truck. You can't turn that valve inside the bracket. Once off I recommend using the Replacement 1/4" Elbow for Air Lift Ride Control Air Helper Springs - Qty 1 item # AL21837 in case you have a bad fitting that way you do not have to repeat this process again. I wish there was an easier way but those brackets are built so closely to protect that...
view full answer... - Adding 2 Gallon Air Tank to Firestone Air Command F3 Compressor KitAir Lift has a 2 gallon air tank part # AL10980 that can be used with your Firestone Air Command F3 Compressor System w/ Wireless Remote and Heavy Duty Compressor # F2590 which is capable of handling the 125 psi you need. A 2 gallon tank like this is a great size as you have plenty of capacity for most uses and it's not so large that it's hard to find a place to mount. To connect the air tube of your kit to the tank you'll need two of the fittings # AL21837.
view full answer... - Parts Needed To Add a Air Tank And In-Cab Gauge To Air Lift WirelessAIR Compressor SystemIf you are planning to use a Air Tank # F9126 with your Air Lift WirelessAIR Compressor System # AL74000EZ you will need some fittings and air line to get a gauge installed. Between the compressor and manifold on the Air Lift WirelessAIR you will need to install a Air Lift Union Tee # AL21838 so that the air tank will be filled by the compressor directly. From there some Air Lift 1/4" Synflex Air Line # AL73RV will attach from the compressor to the air tank with a 1/4" Elbow # AL21837....
view full answer... - Air Compressor for Air Helper Springs and Correct Fittings for Stainless Steel Air LinesYes, there is another compressor that will work with the stainless lines of the Air Lift LoadLifter 5000 Ultimate Air Springs item # AL88399. The item # AL74000EZ is a great wireless system but if you are wanting something without all its capabilities, I recommend the Air Lift Load Controller Compressor System for Air Helper Springs item # AL25856. This is also a heavy duty dual path air compressor but without the wireless functions. To utilize the nylon lines that come with the air compressor...
view full answer... - Replacement Elbow for Air Bag SystemsTo replace the elbow on your Air Lift item # AL88299 kit you will need the Replacement 1/4" Elbow for Air Lift Ride Control Air Helper Springs item # AL21837. The replacement elbow has a 1/4 NPT threaded fitting and the other side has a snap in fitting.
view full answer... - Troubleshooting Air Bag Helper Springs On a 2010 GMC Sierra 1500 With Air Lines Not AttachedSince your sir supply lines were detached I recommend starting by removing the air springs from your 2010 GMC Sierra 1500. This will allow you to check the condition of the air bag springs to determine if they are even usable. Typically when an air spring is run without any air pressure the spring can fold on itself and become pinched and damaged. It will also allow you to find any manufacturer tags located on the mounting plates. You may also find some numbers stamped into the rubber portion...
view full answer... - Can Air Tank be Added to Air Compressor and Bag Kit for Truck Air HornAir Lift has a 2 gallon air tank part # AL10980 that can be used with your current compressor setup. A 2 gallon tank like this is a great size as you have plenty of capacity for most uses and it's not so large that it's hard to find a place to mount. To connect the air tube of your kit to the tank you'll need two of the fittings # AL21837.
view full answer... - Replacement Elbow Fittings for Air Lift LoadLifter 5000 Air Bag System for 2003 Dodge RamIt sounds like you're looking for the Replacement Elbow Fitting for Air Lift Ride Control Air Helper Springs - 90-Degree - Qty 1 # AL21837, which are the 90 degree elbow fittings used on the # AL89295. There's a chance that if the elbow fitting stripped that the brass fittings on the bags are also damaged; if this is the case you'll have to replace the bag using the Replacement Air Spring for Air Lift LoadLifter 5000 Ultimate System # AL84293.
view full answer...
Do you have a question about this Accessories and Part?
Info for this part was:
Installed by:
Kathleen M
Written by:
Mary K
Updated by:
Wilson B
Updated by:
Noah M
Edited by:
Amanda M
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Product Experts Available Now!
Call 1-800-940-8924
Jenny N.
12/1/2021
The easiest way to see if you have a leak is to mix a spray bottle with soap and water, then spray the soapy water mix on all of the air bag components with the air bags filled up. If you see any bubbles that is a leak, and you will need replace or fix the leaking component.