Ultra-Fab Products RV and Camper Hitch - Frame Mount Hitch - UF35-946403 Review Video

The Torflex Lift Kit #K71-707-02 may be exactly what you need for your Winnebago Micro Minnie 1706FB with tandem torsion axles but we do not have any database of axles and I was unable to find the specific axles on your trailer in my research. This…

You'd need to box the I-beam frame where you plan to install the Ultra-Fab 2" Trailer Hitch Receiver #UF35-946403 and then you can weld it in place. You'd need to weld around the L-bracket basically of the hitch to the frame.…

The Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames #UF35-946403 is an adjustable hitch that will fit inside 2002 Nash 19I with I-beam frame as long as you have clearance at the rear when inserted on the inside of your I-beam. It is…

There is a solution for you, but the lift kits you referred to such as #K71-725-02 will not work with welded on torsion axles. The best option is for you to simply remove your torsion axles and use the Timbren Axle-Less Trailer Suspension System…

I went out to our warehouse to take a look at the Ultra-Fab 2" Trailer Hitch Receiver #UF35-946403 referenced in your question. The smaller inner crosstube measures 2 inches x 2 inches and the outer crosstube measures 2-1/2 inches x 2-1/2…

I have a solution for you, but we do not offer that exact light that you've mentioned. However, from what I was able to find out, that light is a surface mounted LED light with a switch that is approximately 9" long. I recommend taking a…

Yes, if you plan on bolting the Stromberg Carlson Adjustable Accessory Hitch Receiver #SC45MR on then you would need to drill holes in the adjustable arms in order to set them to the correct length. There aren't any predrilled so that this one…

You could weld the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames #UF35-946403 to the box frame that's welded to the frame of your 2019 Grand Design Imagine 2600RB travel trailer but would need to have a fabricator come out and look…

Okay let's get started here with the suspension for your 2012 Skyline Koala 27CDS with 3,500 lb Axles; for the first part regarding your equalizers and suspension upgrade kit, so long as your current equalizer is spaced 6 inches (or close to it -…

Yes, all of the correct bolts and hardware are included with the MORryde Suspension Upgrade kit part #MR58ZR that you referenced.

From the crosstube to the face of the receiver is 5-1/4" for the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames #UF35-946403. I've attached a dimensional photo for you to reference as well.

The Curt #C13704 hitch can be used on a trailer with frames up to 66” wide. For frames up to 68-3/8” wide order the Lippert #LC240220, or if you need smaller order the Curt #C13701 for frames up to 51” wide. This last Curt hitch has a 2” drop that…