Custom Fit 2015 Subaru Outback Wagon Accessories

Hey Parrish, There was a design change in the Draw-Tite Max-Frame Trailer Hitch Receiver #76227 so it unfortunately only comes with one hitch pin hole now and there unfortunately are no other compatible hitches available with a second hole for a…

I definitely understand being a bit overwhelmed by the amount of options in front of you, however I can definitely help with differentiating the trailer hitches for your 2019 Subaru Outback Wagon along with explaining my personal recommendation,…

The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118467 is the one I recommend over the other two for your 2015 Subaru Outback 2.5i. This brand of harness has less issues than the others. The Hopkins #HM11143885 and the Curt…

The amount of torque needed for the hitch ball you have installed on your Blue Ox weight distribution will be based on the hitch ball you have. Some require a great deal of torque like the Curt hitch balls like the #C40034 that require 450 ft lbs…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a…

The Draw-Tite Max-Frame Trailer Hitch Receiver part #76227 which is a fit for a 2010-2019 Subaru Outback will install via eight total 10mm nuts which are actually reused as they are the factory fasteners for the bumper beam. The most up to date…

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only…

The first thing you will want to check is the in line fuse on trailer wiring harness #118467. If it is blown or missing that could be the root of the problem. Installing this harness can be a little tricky if the vehicle has factory backup sensors.…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The foam panel is in the bumper to help support the bumper panel as well as provide a cushion for the cover if there is a minor collision. Without the cushion the cover will tend to break or crack easier as it does not have the support needed. I…

Yes, the etrailer Trailer Hitch Receiver part #e98847 which is a fit for a 2014 Subaru Outback Wagon does indeed fit models with dual exhaust.

In order to get a ball mount that has effectively 0 inches of rise or drop you would need to get a Trailer Hitch Ball Mount, part #D-4, like the one you referenced that has a 2 inch drop, and then use a 2 Inch High Rise Ball, part #C40034. I…