Trailer Wiring Harness Installation - 2010 Chevrolet Equinox 118494 Video

The wiring harness you will need for your 2010 Chevrolet Equinox is the Curt T-Connector Vehicle Wiring Harness, item #56094. The installation is different for the 2010 Equinox and you will need to install the connectors behind each taillight on the…

I found an online copy of the owners manual for the 2014 Chevy Equinox from Chevy and have the towing information for you. The models with the 2.4 liter motor have a gross trailer weight capacity of 1,000 pounds if the trailer does not have brakes or…

If your 2013 Chevy Equinox came with the factory trailer hitch and there is trailer wiring present you have the tow package and the correct trailer wiring harness you'd need is the #118264. Otherwise if you do not have the tow package you'll…

I spoke with a local Chevrolet dealer and activating the tow package on your 2010 Chevrolet Equinox is more involved than having the fuses in place. They said depending on your specific vehicle, a few additional components may need to be added and…

If your 2014 Chevy Equinox did not come with the factory tow package, then the factory connection point is probably not functional. You can test it with a circuit tester such as #PTW2993 while someone runs through the lighting functions on the…

It means that the vehicle, when properly equipped, can tow a trailer that weighs up to 3,500 pounds. If your 2012 Chevy Equinox is a model that is rated for 3,500 pounds then you will not have a problem towing a trailer weighing up to 3.052 pounds.…

The T-One Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector #118264 is a great option for a wiring harness on your 2013 Chevy Equinox for use with your cargo carrier's light strip. I have added a link to a video…

We do have wiring kits, that will work with your 2012 Chevrolet Equinox, that do not require the vehicle have a tow package. However, the item you selected, Tow Ready T-One Vehicle Wiring Harness, part #118264, will only fit the 2010-2012 Equinox…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…