Viair Automatic Portable Air Compressor Review Video

I recommend the Flint Hill Goods Wheel Chock #FHG97ZR because it's a solid rubber construction and it features a grab handle which makes it easier to remove from under the trailer wheel than those that don't have a handle, and it just makes…

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

I recommend keeping the Viair Automatic RV Portable Air Compressor #VA59WR in your class A RV motorhome. This compressor will connect directly to your battery with its 12 volt battery clamps. It includes 60' of coiled air hose that will allow you…

The only difference between the Viair Portable RV Air Compressor Kit part #VA39WR and Viair Portable Air Compressor part #VA96WR is that the RV Air Compressor has a longer 30' hose so you can reach your towable tires easier whereas the Standard…

If you are worried about the compressor overheating at those pressures, I recommend using the Viair Automatic RV Portable Air Compressor #VA59WR. This portable air compressor will work with tires up to 40" in diameter and has a fill rate to…

Thank you for the photo of your camper's axle tag. Based on the serial number the correct lift kit is indeed part #K71-723-01 that you referenced, but I did check with Dexter Axle to make sure. This 2-5/8-inch lift kit will work only with…

I can absolutely confirm the correct lift kit for your trailer. Based on your photos, you do in fact have a #10 Torflex axle, and they are compatible with the lift kits because you do not have 3" high-profile brackets (which just means the…

You can replace your older WF-8735P converter with the Progressive Dynamics #PD9130LV converter and lithium battery charger. Yes, you could upgrade to a 60 Amp converter, but you would then have to replace your power center for larger service and…

On a 30 amp trailer with lithium batteries you will want to stick with the Progressive Dynamics 9300 Series RV Converter Charger #PD49RR. Only the amperage output is higher on the 40 amp converter; the efficiency is exactly the same for both.

The Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9130LV would replace the WFCO converter you have now. The #PD9130LV will give you ability to charge a Lithium battery like it sounds like you have so you'd have no use for…