RockyMounts Fork Mount Bike Racks Truck Bed Track Review Video

The RockyMounts Truck Bed Track for Fork Mount Bike Racks part #RKY10993 which is a fit for a 2022 Honda Ridgeline works best with the RockyMounts LoBall Truck Bed Bike Carrier part #RKY1095 which is a fork mount.

I went out to the warehouse and pulled the Kuat Dirtbag, #DRT9P. The overall width is 5-3/4 inches (146mm), and 5 inches between the 2 uprights (127mm).

Yes, the RockyMounts Truck Bed Track for Fork Mount Bike Racks #RKY1097 that you referenced is compatible with the RockyMounts LoBall Locking Truck Bed Bike Carrier #RKY1096 that you referenced and comes with the needed hardware to fit the blocks…

In order for the Yakima SweetRoll Kayak Carrier w/ Tie-Downs - Saddle Style - Rear Loading Item #Y04074 to fit, the crossbars you are securing them to must be no wider than 3-1/2" and no taller than 1-11/16". The Thule TracRac #TH27000XT…

The Hullavator #TH898 mounts via T-Trac so they would work with the TracRac Ladder Rack #TH29056XT. Depending if you have the new or old Tracrac you may have to trim the spacer of the T-Bolt to get it to fit. If you have the newer model it will work.…

Since the Thule TracRac SR Sliding Truck Bed Ladder Rack w/ Cantilever #TH43002XT-781EX uses crossbars that are slightly larger than regular roof rack crossbars you need to used a kayak carrier that mounts using the tracks. For a Thule option this…

Yes, the Thule Hullavator Pro Kayak Carrier and Lift Assist part #TH898 will work with a Thule TracRac TracONE Truck Bed Ladder Rack like part #TH27000XT. That said, you'd need to use the channels inside the crossbars for mounting, remove the…

The Inno Velo Gripper #INRT201 will still work with the bike front wheel turned as long as the Gripper has something to grab onto. If it was just one Gripper holding the whole bike then there might be a stability problem. But there are 2 included so…

I do have an option for you that will allow you to not have to splice into your taillights, but we do not have a product that is similar to the Leer 300200 harness. The Tekonsha T-One Vehicle Wiring Harness #118384 will connect in line of the factory…

You can use 7-way trailer wiring with the module part #PP20-702 to provide power to the third brake light of your camper shell/cap. Basically the stop/turn circuits of the trailer wiring need to run to the yellow wires of this module and then the…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

Yes. The Thule Hullavator Pro #TH898 will fit on Yakima HD Crossbars like the #Y01157 mounted either in the channels or using the clamp on mounts. Since the Hullavator Pro does not come with locks included you may want to consider adding those with…