Gen-Y Auto Latch Gooseneck Coupler Lock Review Video

Hey Susan, so we don't have any locks designed to lock a gooseneck coupler's inner tube to the outer tube that is welded to the trailer chassis so the best option we have would be a wheel lock like the part #288-02020 which will…

The puck feet on the Gen-Y Hitch Gooseneck Trailer Hitch for Dodge Ram OEM Puck Systems #GY83XR is just to help stabilize the ball mount and does not lock into place in the puck. The locking mechanism on top will lock the shank into the gooseneck…

You'll need to do some slight measuring to ensure the fit of the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV on your 4WD 2022 Ford F-350 FX4 dually. Just measure from the top of the rear axle to the top of the…

Thanks for the picture and congrats on the new trailer! There is only one replacement option for the Turning Point Pin Box and it is the Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box item #GY48GR. Reese doesn't have one. The Gen-Y…

Lippert 1621 5th Wheel Pin Box - 15,500 lbs Item #LC1191191 weighs approximately 100 pounds including the wings the pin box bolts to. Lippert 1621 5th Wheel Pin Box - 21,000 lbs Item #LC1387882 weighs approximately 115 pounds including the wings the…

You could probably extend the wires individually of the Valterra EZ Valve Electric Waste Valve for RV Black Water Tank #E1003VP but we don't an extension harness made specifically for this.

Yes, Bristol is just the manufacture of the product. As long as the opening diameter and fitting type is the same then you can absolutely use one in place of the other. Unfortunately, we do not carry Bristol products but I have attached our waste…

Superchips states that with their programmer part #SU1845 installed on your 2012 Ford F-150 with a 5.0 liter V8 you would expect horsepower gains of up to 24.4 and torque gains of up to 24.6 ft lbs.

Once the programming is complete you would be able to remove the SuperChips part #SU1845. It only needs to be connected when programming. After that you could put it in the glove box.

The best and easiest way to install a round 4" tail light like the Miro-Flex LED Trailer Stop/Turn/Tail Light part #STL23RB on a trailer would be to first clean the edges of the holes (no sharp metal) and then spray some soapy water on the…

When used with the #A45GB grommet, a 4-1/2 inch diameter hole is needed to flush-mount a 4 inch taillight.

Since you are pulling a trailer that weighs around 8,500 lbs. you would just want to stick with the Firestone Ride-Rite Air Helper Springs #F35FV (5,000 lb.). You really only need to spend more for the Firestone Ride-Rite Red Label Extreme Duty Air…